Kundeanmeldelser for VEVOR CH-70 hydraulisk hullstanser, hullstanser, 35T flat kobber elektrisk pumpe L-stil, CP-700 H-stil CFP-800-1 samleskinne wolframstål

Amazing time saver. Wish I had this 10 years ago. Multiple dies can be purchased fairly cheaply. Pays for itself the first job.

Wicked little punch for the price. Doing a commercial construction project that I need to hang various lengths of angle iron. Rather than paying for take off and fab cost decided to buy 20' sticks and fab onsite. Punching 1/4" and 3/8" angle iron. So far ~200 holes flawless. I'm about half done. The ch70 and GYB-63D 750w 10k psi Vevor hydraulic pump paired beautifully plug and play and are paid for in the cost of having the iron fab'd by a shop. And I'll have a punch for future. WELL worth the price. Punch a hole in 5-10 seconds vs minutes drilling, I'd probably have spent at least half the cost on drill bits.

will punch a 3/4 hole though 1/4 plate all day long when paired with vevor air hydraulic pump. saves alot of time drilling

Did as advertised outside of the box. Worked first time. Alot of flex when pressing but it's expected.

Good evening: I'm using the CH-70 punch press with dies I bought from AliExpress. I have to say they're quite poor quality; several have already broken, but I can't find them anywhere else to buy. Today I started punching 4mm stainless steel plate, and two 5mm diameter dies broke immediately. The first time, the hole was made, but the second time, not only did it fail to drill, but the die broke and bent the plate. To try and straighten the plate, I removed the die from the punch press, screwed in the punch press's locking mechanism, and placed five 4mm wide plates on the base of the punch press. Then I placed the bent plate on top of the plates and pressed the pedal to straighten them. Unfortunately, I heard a clicking sound, which turned out to be the locking cap that normally holds the die in the threads. The locking was so severe that I had to cut the locking cap off the punch press with a Dremel tool to remove it. I would be grateful if you could provide me with a new locking cap or tell me where I can purchase one and its price. I would also appreciate it if you could tell me where I can buy higher-quality dies that are suitable for stainless steel plates. Thank you very much.

Haws. After 2 years in my commercial fab shop it still punches with the original dies. Has paid for itself 100 times over literally! Wish I could find replacement dies for it in different sizes.

This thing is stout. No Regerts! Would like to have larger and smaller dies. It will punch more than 3/8 mild steel. It is quite heavy to move but my neighbors love it just as much as I do. Great addition to any home shop.

Excelente perforadora, la recomiendo ampliamente.

Very good — works as described — small issue with a duplicate base die but it was corrected by Vevor extremely fast — very happy

Good tool. Pity Vevor did not sell the punch tooling but nonetheless good tool.