Kundeanmeldelser for VEVOR CH-70 hydraulisk hullstanser, hullstanser, 35T flat kobber elektrisk pumpe L-stil, CP-700 H-stil CFP-800-1 samleskinne wolframstål

Good evening: I'm using the CH-70 punch press with dies I bought from AliExpress. I have to say they're quite poor quality; several have already broken, but I can't find them anywhere else to buy. Today I started punching 4mm stainless steel plate, and two 5mm diameter dies broke immediately. The first time, the hole was made, but the second time, not only did it fail to drill, but the die broke and bent the plate. To try and straighten the plate, I removed the die from the punch press, screwed in the punch press's locking mechanism, and placed five 4mm wide plates on the base of the punch press. Then I placed the bent plate on top of the plates and pressed the pedal to straighten them. Unfortunately, I heard a clicking sound, which turned out to be the locking cap that normally holds the die in the threads. The locking was so severe that I had to cut the locking cap off the punch press with a Dremel tool to remove it. I would be grateful if you could provide me with a new locking cap or tell me where I can purchase one and its price. I would also appreciate it if you could tell me where I can buy higher-quality dies that are suitable for stainless steel plates. Thank you very much.

CH 60, Punches 1/2" 6061 / T65111 aluminum like it's paper. Used a hand pump with 1 hand and punched 5 holes with no real cleanup compared to drilling. Wish I can find resonable priced punches. Seems like the ch70 has better less costly options than the ch 60. Not sure what hydraulic connection they provided, but I swapped to a more common connection to match my Enerpac 10k hand pump.

Se me ha partido el punzon de 10.5 en el primer uso. Material muy malo

Nu am fost informat in prezentare ca nu poate fi folosit fara alta componeneta si am fost nevoit sa .ai comand alt echipament la fel de scump. Consider ca am fost inselat. Atentie ca nu sunt seriosi.