Kundeanmeldelser for VEVOR 2 hk båndsliper med konstant hastighet, 2 x 82 tommers båndsliper med 3 slipeskiver, 110 V benksliper, 12 tommers hjul og flat plate, verktøystøtte for knivproduksjon

die Lieferung war etwas schwierig, aber das gesamtpaket mit service sehr zufriedenstellend.

I don't use it for knife making. Just general metal work. Overall a good and stable machine. Some older YouTube reviews talk about no on/off switch. That was apparently on the older machines. Mine has a good on/off switch. Heavy duty. If I have a complaint, it's that the speed is extreme on the high side. It runs so fast that the vibration makes it somewhat dangerous. I've bolted it down as tight as possible and checked every nut & bolt for tightness to try & reduce the vibration from it's extreme speed but to no avail. I'm now looking into a router variable speed controller to try & reduce the speed a bit. The one I have is 20A and blows the fuse as soon as it starts up. So I'm trying to find one that has a 30A fuse. On startup, it pulls a LOT of power so a dedicated 20A circuit breaker is a must.

Very handy grinder

Das Bandschleifgerät ist einwandfrei und war solide verpackt. Allein die Zeitdauer der Anlieferung hat Verbesserungspotential.

Despite some poor reviews, I found my grinder was well adjusted and performs well straight out of the box. Some practice is required to set the belt tracking, but once set the belt tracks well even under load. Good value for the money.

Bonjour, Je fais de la coutellerie amateur et je trouve ce mini backstand plutôt satisfaisant. La puissance est suffisante. La qualité est plutôt bonne même si certaines choses pourraient être améliorées (taille des vis un peu courte, support de guide trop petit ). Les bandes se trouvent facilement.

Good machine for the price. Fewer quality control issues than some youtube videos talked about. For the one I purchased: ~ the drive wheel, tracking adjusting wheel, and the vertical platen wheels do not track in the same plane. I am figuring how to bring them into alignment so that the belts track correctly. ~ the lower wheel on the vertical platen does not turn freely … bearing already bad?

Gutes Gerät mit sehr gutem Preis-Leistungsverhältnis. Leider sind die Passungen nicht hundertprozentig genau, so dass man anfangs die Rohre mit einem Hammer in und durch die Passungen treiben muss. Vermutlich ist die Beschichtungen in den Passungen zu dick aufgetragen.

Très content de l'achat , SAV le meilleur et de loin.

Très bon produit, idéal pour débuter en coutellerie