Kundeanmeldelser for VEVOR 1200 mm flisekutter, manuell flisekutter for keramiske gulvfliser med høy presisjon, 48 tommers skjæremaskin for presisjonsskjæring

The alignement of the cutter on the base is offset You have to align it and drill and grind the plastic at the end of the frame The frame is to soft When you cut and try to press to split the tile, the frame bind and it become hard to split I have to had steel piece under all the lenght the strength the frame After all that it's a good cheap tool

Quality is ok. But the middle flexes to much and doesn't score the tile. Other ones have support there. So I have to push down on the center section. Not fun. Wish I would have returned. Not a good long term solution.

Don’t wast your money on this. It’s too flimsy. For large tile rip cuts, you will end up breaking so many pieces of tiles that will cost way more than you would save from a cheap tile cutter.

Could not get the laser to calibrate. Not easy to line up. Once lined up it cuts nicely.

The cutter is not square so the laser does not help. To make exact cut, it is necessary to place a tail checking whether the cutting wheel is placed on the top of the intended cut line on the one side of the tail, then on the other side so preparing for the cut takes time and adjustment. Beside of that, the video of the product and the manual attached to the product depict totally different version of the cutter (the real one does not have side supports and adjusted angle ruler). Customer service was not helpful at all so I did not get any replacement, I had to use what I got.

Very good tile cutter but, the laser line it's useless under the sunlight, the alignment can't be relied upon. If it had a decent strong laser line which could be adjusted by user and a decent top ruler that is accurate, easy to see and long enough for large tile I believe it vould be a competitive tile worldwide. I did a decent job with it but by only ignoring the laser line and marking my tiles first using a tape measure. Despite all this if you are not a perfectionist then you will not find a cheaper cutter anywhere. Cheers

Not the best, have to make alot of adjustments to get straight cuts, laser is never aligned with cutter don't bother using laser.

The product might be good but they used evri for delivery and it never arrived. I will not be ordering again just because of the chosen delivery service

Works well for shorter lengths. Lacks strength for larger 4 ft porcelain tiles. Tried several tiles. Scored fine, but did not snap along long scores. Ruined several $75 tiles. Works fine with smaller tiles, bar bends with larger tiles. Planning to return.

Hola buenas ,la maquina no tiene mala pinta pero me a tocado una que esta doblada que no corta recto.quiero por favor una nueva o la devolución.gracias