Kundeanmeldelser for VEVOR 180 W edelstensfasetteringsmaskin 220 V edelstensliping 40 x 20 x 22 cm fasetteringsmaskin for polering og skjæring

Polecam na początek chociaż instrukcja jest mało zrozumiała ale. Idzie dojśc co i jak i można zacząć pracować czy do celów hobby wykorzystywać. Fajnie gdyby w komplecie były tarcze różnej gradacji.

Machine needs to be looked over to be level and plumb, bolts and screws should be tightened and situated to ensure proper cuts. Other than that its a good tool to start!

I am using this machine to cab glass. I am enjoying it to a point. I also am using my hands to do this, not all the angled holders and such. Today, I used it for my third or fourth time. These are my issues: During set up 1. A few things were not mentioned in set up procedures and I had to source several different similar machines to see how the water spigot and pump should be set up. They were not described nor displayed. 2. The hoses wouldn’t fit well and I could not do the clamps up tight enough myself so I had to get help. 3. The plastic clamp tighteners feel flimsy **Now, a short time of use. 4. The clamping bands are not stainless so they rust into the water surrounding the pump and the pump might get ruined by this. ** 5. The water dripper handle might be great for small handed lefties (small area and weirdly angled?) but I have small hands and find it awkward. 6 I am having to adjust the water a lot. It seems to run on too slow a drip or too much. 7. The hose coming in is never fully filled but does operate. The one coming out of the machine arrived bent flat at the machine and I have had to add some gravity to assure drainage. It works.

I was very pleased with this item. I was not expecting it to be as good as what it is because of the price but was surprised. I would definitely recommend this product for someone thinking about this hobby.

For the price this machine is amazing. However I wish the protractor was easier to see and there were more laps and stops that came with it. The mast was not great. Cutting at 90 degrees is very difficult. Otherwise it's a fantastic machine for the price.

I purchased this machine and the cutkit1 from facet.ing and was able to learn the basics pretty quickly. The stock vevor machine isn't able to grind girdle facets, among other issues, so I added the cutkit 1 which is sold by another company. The machine itself has some sloppiness that makes perfection difficult, but it is a solid choice for a learner on a budget.

Overall, I am mostly pleased with my purchase, but after use of the machine, the speed control seems to fail while working on a stone and the machine seems to get really hot. I have adequate airflow around the machine but the whole machine gets hot to the touch.

Works ok, but the start/stop switch is a little squirrely; you have to push it a half dozen times before it will turn on. Additionally, the water pump works ok, but it doesn't have a switch. You have to plug it in and unplug it to start and stop.

Machine operates fantastic, I do wish the mast and protractor were a bit more robust or that an optional mast and protractor were available. Overall is a very good entry level machine.

Hars to dial in proper settings for faceting. Wish they would offer an upgrade to a digital one or make it better. It harder to cut smaller stone girdles because it won't go low enough. A shorter shaft for the dop would be better since cutting girdle/pavilion the mast is hanging off the machine. Otherwise it's an ok machine to start off with. TurtleHoard has upgrades for it that make it a bit better.