Kundeanmeldelser for VEVOR 2 HK bassengpumpemotor, 56Y-ramme, 230 V (7,8 ampere) 3450 o/min, 60 Hz, 1,3 servicefaktor, 50 μF/250 V kondensator, moturs roterende firkantflens-erstatningsmotor

Works great so far ! A little longer than my old one but no problem fit perfectly!

This electric motor is of great quality and works as advertised also you will not beat the price.

Great price for a very good motor

I used this motor to replace a 1.5HP motor on a Pentair Whisperflo pool pump about 4 weeks ago. I wired it as a 240V (vs the optional 120V). It's working great so far. The "service factor" for this motor is lower (1.1 vs 1.4) than the original Pentair unit so time will tell if the price was "too good to be true", but so far I can't tell any difference. Price was excellent and delivery was amazingly fast. A gripe is the space for wiring connections is tight on this motor making an in-place replacement a little more difficult. I do wish you could grip the motor shaft to tighten the pump impeller without removing the end cover but that's no deal breaker. I liked this motor so much I ordered a 2nd to have on hand as a spare.

Amazing deal. Installation went smooth and works perfectly for half the price others charge and arrived on time as promised. I'll be back for all of my pool and spa motors.

Amaizing price without compromising quality, love how quiet the motors are, will definitely keep buying them

This motor seems to be as good as any of the $300 + motors I’ve bought. They last a few years. We’ll see how this one does.

Quoted $2800 by our pool guy to change out dead pool pump. The pump itself wasn’t dead, just the motor. So for $130 shipped I had it fixed in 30 minutes! Motor has been running for 7 hours a day on the pool pump/filter for 3 months now no issues!

So far so good. The price was great. The motor was as advertised for a pool pump motor replacement. Quality appears to be good but only time will tell. The only challenge was installing the leads with lugs already installed. With a flex connector installed there is very little space to get leads through due to location of a board inside the motor. It probably would have taken less time to install if I would have cut the lugs off before running the leads. Otherwise, I would buy again if it is shown to be reliable.

The motor is direct replacement for Century 1.5hp 56y frame used on Hayward pool pumps. Very easy bolt together project. A few reviewers complained about wiring connections but while rather tight it was easy enough by using spade connectors on my wiring. Some also complained the motor is noisy but I think those people are hearing more pump noise than motor noise. The sound from motor is normal electric motor hum, the bearing are relatively quiet. All said this motor is a good value