Kundeanmeldelser for VEVOR 3-punkts tilhengerfeste, 2-tommers mottaker, 3-punkts hurtigkobling med 3 tilhengerkuler, adapter for traktortrekk, kompatibel med Kubota, Mahindra, Ford, Yanmar, John Deere, Massey Ferguson

It appears to be too high to attach to the top link on my Kubota Quick hitch system without some adjustment. I haven't installed it yet but at first look it will require some adjusting which I was not expecting.

Generally, the item is described accurately, BUT the quality of the metal components are insufficient for anything other than light-weight work. Specifically, the tube for the receiver is much too light weight. The manufacturer should have used true 2” Hitch Receiver Tube for the receiver. Any real pulling will damage the product. My product bent inward on the sides and flared outward on top and bottom (of the hitch tube). In order to get any value out of the hitch, I will need to repair and rebuild my item. The lift pins are of good quality. Overall, I would spend a little more money on a better quality item unless you can accept compromise.

It was discovered after receiving this item that it will not mount onto a quick hitch. This item was purchased specifically to be able to add a drawbar for a ball hitch or to mount my tool carrier, without having to remove the heavy quick hitch each time. But the spacing of the bracket for the upper arm of the 3-point hitch is too shallow to accept the top "hook" of a standard quick hitch. Happy wth the product otherwise. (Quality looks fine but who can judge until some time has passed so cannot really rate that - but it was a required field so i went in the middle with 3 stars.)

Le produit était clairement d'occasion des accros sur la peinture un peu partout ça sentait un retour refoulé c'est bien dommage quand on achète du neuf on veut recevoir du neuf.

This thing is terribly made out of very thin steel likely 1/8" The plates that are welded on for the top link pin to go through are crooked and the holes are misaligned. I had to beat it in to my quick hitch with a 4# hammer, but ultimately was able to make it work. It is covered with welding spatter everywhere. For the price, I could accept the light duty construction, but it is extremely poorly made.

Hi, your product was made too narrow for the three point linkage, the top link was too tight to take a Top link, the welding was very poor on the linkage. So all in all it was a very poor equipment.

Product (3-point receiver hitch) looks well made but do NOT buy if you expect to use on a John Deere iMatch quick hitch. Contrary to the AI question in Q&A section, it will NOT fit - too narrow to fit into lower pin slots. Without the iMatch quick hitch I expect it would work fine. Had to send mine back.

Come da attese

First time I used the 3pt trailer hitch to lift my equipment trailer it opened up like a sardine can and dropped my load. The manufacturer used two thin layers of metal mig welded together and thought this was sufficient. Bad engineering and unsafe as well.

à la première utilisation pour travaux léger le frame c'est tordu avec une petite racine de +/- 1/4 de pouce. Ne pas acheter....