Kundeanmeldelser for VEVOR 37,77cc bensindrevet T-stolpedriver, 4-taktsmotor bensindrevet gjerdepælemaskin, med 2-stolpe drivhode (55/70 mm), 1000W bærbar pæledriver for gårdsbruk, ranchgjerder, veiforbedringer

this thing really save you time and saves your body. one of the best things I ever purchased, I love vevor products

used this to drive Lifetime Steel Posts. "How did you a 4" wide post firnin a 3.94" hole?" you might ask. we compressed the post slightly across.the width using 2.5" 5/16" bolts in the top two holes. worked like a champ! and this machine starts with the lightest pull I have EVER seen. it is amazing.

This tool saved me many hours of work, and I really could not have done this job without the post driver. I used it to drive 2x6 boards into the ground in front of a lake wall to seal the areas undercut by the lake eroding the soil under the original wall. I tried driving these boards in using a sledge hammer into a heavy clay soil (lake bottom) and was only able to get 8" deep. The post driver was able to get to an average depth of 15 inches. I made an adapter (on 2nd board from right in the picture) to connect the driver to the boards. Like other have noted, using the low speed, just a bit above idle worked best. And when it reaches a point where no further progress can be made, stop to avoid breaking the tool or your work. It is slow but steady. Super easy starting.

One of the best investments you can make, if you have post fences. I had to put in a total of 60 post, both pipe and tbar. 2 hours, 1.5 tanks of fuel. Worth every penny.

Works really good drives tpost fast

Easy to set up and use. Used to install poles for a chain link fence and also used on putting in dock poles. Works at it should, no issues for the last 3 projects over the last 9 months.

This post driver works very well. For the price I have no complaints so far , it’s starts up right away every time . It is a little heavy but you need that weight to drive the post. What a time and labor saver !!!

Aucun regret pour cet achat..merci

We were about to give up trying to get this to drive a t-post and had even reached out to return it. We found a youtube video that gave us some tips on what to do. You will need to let the post driver warm up for 5 minutes then set it on half choke and leave it there. Then when driving the post you don't want to go full throttle. Works like a xharm and seems to get better every time we use it. Of course it's not going to drive through rock but it does work great for the price. Very happy with this purchase!

This machine worked as it should and save me a bunch of time. Started super easy and never hiccuped once.