Kundeanmeldelser for VEVOR Ikke-svingbar freseskruestikke med låsing, 4 tommers presisjonsbenkklemme, 100 mm bredde, borepressklemme, 4 tommers kjeveåpning, for etterbehandling av fresemaskiner, boremaskiner, presisjonsdeler

I have to admit I was on the fence whether to buy this vice and only gave it a 4 star for Quality because of all the the sharp edges .I stoned all the sharp edges off . And I am really surprised at the overall Quality on this vice for the price it is really good .I would buy again. Vice of this calliper elsewere would be a lot more expensive.

Surprisingly well made. A little deburring and corner breaking required (plus ca change) but the vice trammed in easily on the mill table and had virtually no jaw lift. For the price I'd say this was a really good deal.

I've used this vise for a while now and can say that I am pleased with it. For the price the quality is great, the vise jaws are precisely machined, as well as the milled keyways with keys underneath the vise which perfectly fits my milling table, making it super easy to perfectly align the vise to the table, great feature! The base of the vise has small walls that contains flood coolant which I run on my mill, these walls was not quite high enough so i modified it a little to make them higher which works great. Slightly higher walls on the base would be amazing. However it might not be made to run flood coolant but only to collect small amounts of oil and chips, this it works great for. the only drawback I've noticed is that chips from drilling tends to collect inside the vise and jam up either the screw or ways, this can make it difficult to turn the handle and move the vise jaw. I use a small brush to clean these chips away. Overall very pleased with the quality of this vise and for the price its amazing. Recommended.

excellent tool.thank-you.***************************************************************************************************

Great and precise. I use it on my Drill Press. I also bought a 6" version for my Grizzly Milling Machine.

I might be just a novice at milling and lathe work, but this vice has been the best addition to my mill. It's built well for the price and to be honest, built better than expected. Would I advise others ? Most definitely. Unless you're a high-end machine shop that needs extreme precision, this is more than sufficient to do the job. Need to see how their tools fair and the next on my list Vacuum pump ???

Nice vice, tight tolerances. The 4" vise was a bit overkill for my Sieg SX2 mini mill, should have gotten the 3".

Quick to arrive and quality seems to be really good. Would recommend.............................................................................................................................................................................................................................................................................................................................................................................................

Accurate and sturdy. I would not hesitate to recommend this wholeheartedly. Best of the lower priced vises I have seen

Wow. Very well made and for half the price of other import brands and a fraction of the US made ones. I haven't put it on the flat plate yet to check run out but even if I have to spend a few hours tuning it up it'll be a great buy.