Kundeanmeldelser for VEVOR 47 tommers flisekutter enkeltskinne doble braketter manuell flisekutter 3/5 tommers hette med presis laser manuell flisekutterverktøy for presisjonsskjæring egnet for porselen og keramiske gulvfliser

It's ok but when you try to cut the tiles it bends. I don't like it.

Bien pour couper des carreaux de première prix, mais pas fou pour couper des carreaux de bonne qualité exemple, j’ai coupé trois carreaux en grès cérame , la roulette était morte.

Overall a great unit. The issues i have with it are somewhat minor and i haven't told vevor about them yet. The light stopped working in the laser line after 5 days of use. The battery cover also broke the clip first time i used it.The support legs dont really support the tiles properly and it rockers 1too much and causes miss scores therefore bad cuts. Would be great if the extension arm supports were adjustable. I just shimmed them up. One of the extension arms arrived half way out of its track amd i didnt want to force it back in. Otherwise it worked amazing....

Great for the price, first small job worked great had another small job and would not cut clean. Installed new diamond wheel and had same issues. Had to hand cut all tiles. So for a one and done it works great but dont expect it to be around for the long run.

uyjk

Works well for shorter lengths. Lacks strength for larger 4 ft porcelain tiles. Tried several tiles. Scored fine, but did not snap along long scores. Ruined several $75 tiles. Works fine with smaller tiles, bar bends with larger tiles. Planning to return.

Board is flimsy and handle is too low. I can not cut any porcelain tile strip less than 2 in.

Bonne qualité a première vue Bien pour les coupes droites mais les diagonales ne se coupent pas bien, carreaux cassés 1 fois sur 3 en diagonale en 60x60 cm Sinon laser pratique mais le plateau est trop souple au moment de la découpe et plie légèrement ce qui fais que ça découpe mal

Lazer not aligned, rusting after use, diamond wheel cutting poor.

Low expectations. Had to cut 9.5mm porcelain tiles and thought would give this a go. It cuts just fine. Need to be aware that the centre markings aren't centre and that the cutting and angle guide are not accurate, not helped by one of the retaining screws being bent. But being the cheapest cutter I could find, very pleasantly surprised. BTW, please don't pay attention to many of the YouTube videos of this style that don't seem to understand that you always split a tile from one or other end, not the middle. This cutter is designed so as only to split from the top.