Kundeanmeldelser for VEVOR 47 tommers flisekutter enkeltskinne doble braketter manuell flisekutter 3/5 tommers hette med presis laser manuell flisekutterverktøy for presisjonsskjæring egnet for porselen og keramiske gulvfliser
Kunde anmeldelser
Hvordan kundeanmeldelser og -vurderinger fungerer
Kundeanmeldelser, inkludert produktstjernevurderinger, hjelper kunder med å lære mer om produktet og avgjøre om det er det rette produktet for dem.
Den samlede vurderingen vår er ikke et enkelt gjennomsnitt. Vi prioriterer autentiske og troverdige anmeldelser og filtrerer ut duplikater eller ugyldig innhold før vi beregner den endelige poengsummen. Dette bidrar til å sikre at vurderingen virkelig gjenspeiler reelle kundeopplevelser.
Anmeld dette produktet
Del tankene dine med andre kunder
Skriv en anmeldelse
46 Anmeldelser
Anmeldelser for Gjeldende Produkt
Verifisert kjøp
Bilder og video kun
Oversett alle anmeldelser til Norsk (Berkmel)
Martin Handyman
The alignement of the cutter on the base is offset
You have to align it and drill and grind the plastic at the end of the frame
The frame is to soft
When you cut and try to press to split the tile, the frame bind and it become hard to split
I have to had steel piece under all the lenght the strength the frame
After all that it's a good cheap tool
0 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
David M Phelps Too much flex
Quality is ok. But the middle flexes to much and doesn't score the tile. Other ones have support there. So I have to push down on the center section. Not fun. Wish I would have returned. Not a good long term solution.
1 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
P1234 Laser wouldn't calibrate
Could not get the laser to calibrate. Not easy to line up. Once lined up it cuts nicely.
0 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
Wit Not square, no customer support
The cutter is not square so the laser does not help. To make exact cut, it is necessary to place a tail checking whether the cutting wheel is placed on the top of the intended cut line on the one side of the tail, then on the other side so preparing for the cut takes time and adjustment. Beside of that, the video of the product and the manual attached to the product depict totally different version of the cutter (the real one does not have side supports and adjusted angle ruler). Customer service was not helpful at all so I did not get any replacement, I had to use what I got.
1 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
Sinan Mr
Very good tile cutter but, the laser line it's useless under the sunlight, the alignment can't be relied upon. If it had a decent strong laser line which could be adjusted by user and a decent top ruler that is accurate, easy to see and long enough for large tile I believe it vould be a competitive tile worldwide.
I did a decent job with it but by only ignoring the laser line and marking my tiles first using a tape measure. Despite all this if you are not a perfectionist then you will not find a cheaper cutter anywhere. Cheers
0 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
Joe Entrepreneur
Not the best, have to make alot of adjustments to get straight cuts, laser is never aligned with cutter don't bother using laser.
0 personer syntes dette var nyttig
Oversett anmeldelse til Norsk (Berkmel)
