Kundeanmeldelser for VEVOR 6-kjevs dreiebenkchuck, 6 tommer (160 mm), selvsentrerende chuck med D1-4 kamlås-bakplate, 0,12–5,71 tommer (3–145 mm) spennområde med T-nøkkelskruer, HT300-materiale, for tre- og metalldreiebenk

tutto ok come descrizione grazie

Sehr preiswertes Futter, robust und gut verarbeitet. Den Camlockflansch kann ich nicht bewerten, habe einen Flansch für meine Maschine gedreht. Die originale Rundlaufgenauigkeit ist für diesen Preis ok (0,07mm gemessen mit Feintaster), durch Nachbearbeitung der Futterrückseite konnte ich das noch etwas verbessern. War ein guter und nützlicher Kauf, kann ich empfehlen.

This chuck was stiff on arrival from leftover machining dust. I disassembled it (easy to do), cleaned all the parts, and reassembled with super lube. The unit is now nice and smooth. Accuracy with a 1/2 in pin gauge chucked is around .001", which is in the same ballpark as the lathe spindle (12x35 Grizzly), so hard to fault the chuck for this application. It was best at one location, so I put timing marks on that position. The unit has a nice range with bolt-on reversible jaws, so very handy for grabbing tubing or other hollow objects.

Came in with smashed box and had been retaped, problem with the shipper not Vevor. Bolts for backing plate were missing, once again I believe because of the broken box. Chuck itself seems to be fairly well made and heavy, jaws are a good fit. Very gritty so had to take apart and clean before use. Mounted and tried it, and T.I.R. was .0075". Set it up and did a minor grind to the jaws and have it to .002" T.I.R. Will run it for a while to loosten it up and then final grind it. I have had to do this with others too. Seems pretty common. All in all it seems pretty good. Backplate runout on face was about .0002" and outside was .0001", very good.

Very pleased with my 8" four jam chuck for my Southbend 10K. Installed quickly and verified trueness with dial indicator. Very satified.

God quality Chuck to a god prize i am wery happy with it, but i wish you could get it with a D 1 backplate 🤔 Fast and uncomplicated delivery 😉

PARFAIT

This chuck is repeatable within .0005" and is smooth.

Très bon matériel de belle qualité

I thought that I would give this metal lathe chuck a try ran a tap in threaded holes then mounted the chuck to the backing plate installed it on the lathe. Now the test run the chuck clamped the round stock perfect now to check the run out .0015 . It will do the job Lathe is an old Atlas Clausing precision metal lathe