Kundeanmeldelser for VEVOR 600 mm flisekutter Enkel skinne Doble braketter Manuell flisekutter 1,5 cm hette med presis laser Manuell flisekutter Verktøy for presisjonsskjæring

Ottimo prodotto qualità prezzo fa il suo anche se il laser pultroppo non e preciso

Ogólnie polecam maszynkę, w szczególności za taką cenę. Trzeba troszkę poustawiać ją, ponieważ kółko nie prowadzi po środku szyny do łamania. Jest kilka mm obok. Druga kwestia to konstrukcja maszynki nie jest ustawiona prostopadle do blokady, więc trzeba znaczyć płytkę z obu stron i kółkiem sprawdzać czy idzie dobrze w linii. Jest to minięcie rzędu 2-3mm. Huśtający łamak jest denerwujący więc trzeba się przyzwyczaić do niego. Poza tymi ustawieniami maszynka jest ok. Zaletami są: niska waga, bardzo dobre kółko plus drugie zapasowe, prowadnica bardzo sztywna więc nie ma mowy o cięciu po łuku oraz wuzek lekko jeździ po prowadnicy.

Tagliapiastrelle perfetta... molto utile

Prodotto conforme alla descrizione, i materiali ad un primo utilizzo sono di buona qualità

It did the job. Took a bit of fiddling lining up the laser light with the cutting wheel but got there eventually.

This work better than I thought. I had to make a few adjustments to get a nice square cut. the laser site is pretty handy. good for the price

Loved the 24" tile cutter and it worked beautifully with one exception. The tubular cover at the top of the centre line is a little too high and the tile does not sit comfortably when cutting. Would I buy it again - Yes.

Clean cuts every time. Instructions could be better for the attachment of angle accessories. Laser light difficult to line up with score wheel accurately but overall very happy.

It cuts so easy , a D.I.Y must have . handles 600mm porcilian tile easily, straight and clean.the only problem I have with it is the cutter is not aligned straight and dose cut straight unless you mark at each end of the tile and make sure it`s going to those marks. I tried to realign the rail and got it to within a couple of mm and it is a pitty that I cannot just put a tile in and just cut it instead of fiddling around linnig up marks because the Rail is not square to the cutter.

The laser light is not neat enough and incorrect guidance. So it make the cutting edge was not correct as required. The balance of the device is not good when putting the tile on to cut. You have to hold the tile firmly when cutting