Kundeanmeldelser for VEVOR 80 mm kraftig freseskrustikke benkklemmeskrustikke høypresisjonsklemmeskrustikke 3 tommers kjevebredde med 360 graders svingbar base CNC-skrustikke

Jeg modtog min skruestik den 06-11-2023 og tog den i brug den 22-11-2023. Jeg borede huller i en plade til en lampeholder. Det gik fint, og den holdt emnet urokkeligt fast. Den blev brugt i lodret posision, jeg har endnu ikke prøvet den i vandret posision, men det kommer nok. Se venligst vedhæftede billeder, hvis de er med, jeg er ikke sikker på at de er kopieret MwH. Bent Delfs

Accurate and sturdy. I would not hesitate to recommend this wholeheartedly. Best of the lower priced vises I have seen

Wow. Very well made and for half the price of other import brands and a fraction of the US made ones. I haven't put it on the flat plate yet to check run out but even if I have to spend a few hours tuning it up it'll be a great buy.

I needed a vise that does not lift the moving jaw and not very large. After checking several tests at Youtube i found I could buy locally but from Vevor in EU I had the best price. Fast delivery as well. I stoned all sharp edges and cleaned everything thoroughly, then reoiled with way oil. After reassembly I have used it several times and I am fully satisfied with it's performance. Since some years I also have a Vevor dividing appararus for my milling machine that works fine. I recommend this vise as good value for money

Tolles Produkt, schnelle Lieferung; kann es nur weiter empfehlen; gut verpackt geliefert, einfache Handhabung.

buena compra, usada para una fresadora pequeña que me he comprado, tiene buen agarre y buena presion a la pieza, no observo holgunas en apriete

Erittäin laadukas, toimii niinkuin pitääkin. Toimitus oli erittäin nopea. Tuotetta voi suositella vaikka ammattikäyttöön.

Very pleased with my purchase. These two smaller vices complement a larger one. I was expecting to see the coolant drain, but this rotating model is perhaps too small for that.

It's cheap and cheerful, for the money it's bloody good, I ran a dti over it and it was within 0.01mm on X,Y&Z. edges needed easing as many youtube reviews have said, The base was pretty good I ran a stone over it and although not absolutely perfect I wasn't concerned about anything. The jaws I will probably replace as when the vice arrived they were ground flat on the top, I assume once assembled. once taken apart there is no repeatability. I had to jiggle them about a bit to get them back trammed with the dti. but hey ho it's not a Kurt and not a Kurt price. I can't really comment on the swivel base as I only checked for parallelism. for the deg if I wanted accuracy I would use a sine bar anyway. One thing I did notice was 0 deg started underneath the screw, making 90 deg to the side where there is a mark for setting, no problem for me though. I have the vice on the bed with no base, used my own T nuts and bolts as they were better. For the money it is very good value in my opinion, and would not hesitate in purchasing another should the need arise .

Très bon étau massif et plutôt précis vue le prix .peut être un peut trop gros pour mon usage, mais vue le prix il ne faut pas hésiter