Kundeanmeldelser for VEVOR justerbart hullsagsett, 1-5/8 tommer til 11-13/16 tommer (40-300 mm), innfelt hullsag med PC-støvdeksel, to utskiftbare pilotbor, for innfelte lys, takhøyttalere osv.

Correspond à mes attente, après plusieurs percement rien à dire. je ne comprend pas pourquoi fournir des forets béton dans le coffret.

Cuts the holes OK, and is well made. But the gasket ring is too shallow and not very flexible. So it does not make a good seal to keep the dust in, especially on textured ceilings. The spring is also a bit weak. When you push hard enough to try and get a good seal, the blades hit the surface before the seal is formed, and the drill bogs down. I ended up wrapping foam pipe insulation around the circumference of the disc to help make the seal and keep the blades away from the surface until they spin up to speed.

Zatím použity na jedné akci při vrtání větších otvorů do plechů 1-3mm. Vrtáky měly celou dobu dobrý záběr a nesou známky běžného otupení. Předpokládám, že jejich použití do dřeva bude luxusní. Značení na vrtácích inch/milimetry je vyražené. Jinak opravdová kvalita se ale ukáže až časem.

Preciso de fatura com número de contribuinte 505347075 MJFANTUNES, Lda Travessa da Cascalheira, 4 2435-522 Tomar

like most Vevor products these are terrific value for the money. The only design fault is that removing the wooden plugs left in the saw is very difficult. Some method of easing their removal would be a huge improvement. The problem can be alleviated to some extent by lining the hole saw with a silicone spray (and allowing it to dry) before use, this reduces the incredible "death" grip of the saw on the plug.

No problems, cuts holes at the required size. I've never had one before so I don't have anything to compare with, but worked fine in softwood and plastic.