Kundeanmeldelser for VEVOR 10-delers kuleleddavtrekkersett, 360 x 285 x 70 mm universelt kuleleddpressverktøysett, karbonstålverktøysett for bil med koffert

Did what it was supposed to do. Really save on this job.................

Hat gut Funktioniert

Used it on a Jeep Wrangler JK to swap out upper and lower ball bearing. Works fine.

Had to do a full front linkage replacement on a 2013 Ford F-150 XLT. Bought this to both press out and press in the lower Ball Joints. First one pressed out with a little heat, second one needed the to be started with a sledge, to overcome the rust ring, but as soon as it was flush, the next tap popped it out. Both new ball joints went in fairly easy. The only issue I had with this kit is the press adapter rings (there are 3) were almost too coarse in diameter to press my joints in, the medium one was too small, the larger one was half on the edge of the ball joint housing. After getting it to straddle that edge evenly, the press went well. It IS quite a comprehensive kit and I'll probably only use it one or twice, bought it because I wanted to make sure I had ALL the adapters I needed and I only needed 4 parts. It would also be nice if all of the plates and tubes had some identifying mark to match a part list, so you know what cars they go to. They do have a application list in the manual but it only applies to 2004 and below cars and trucks.

Work pretty good decent for the price

Sembra abbastanza forte, speriamo che non si pieghi durante l'uso

TODO MUY BIEN SE VE FUERTE GRADE

Works great. Very strong. Lots of adapters for different jobs. Would buy again.

Well guolity

outil parfait mais boite de rangement arriver brise