Kundeanmeldelser for VEVOR ballastboks, 3-punkts traktorballast kategori 1 med 363 kg lastekapasitet, med standard 2-tommers tilhengerfeste, stålkonstruksjon, 0,09 m³ volum, lasterfeste med skyvedør, grønn

It'd fine. It's tiny. Not sure what material you would need to put in it to get to the advertised weight. But it's fine. A steel barrel. Stone and a draw bar probably cost the same. I chose the lazy route. I stuck a shovel in the tool holder. It's stuck around with me.

Die Ware jam relativ schnell. Innerhalb 4 Tagen war die Ware bei mir vor Ort. Das negative ist aber....die Hälfte von dem Lack löst sich durch Rostblasen von dem gerät ab. Zudem sind die Aufnahmen der Unterlenker viel zu kurz und dir mitgelieferten Bolzen dieser Aufnahme viel zu lang. Auch die Klappe welche man vorn öffen kann hat ein Spaltmaß das man Probleme mit dem Ausziehen von Beton bekommen kann. Aber was will man für den Preis erwarten. Wäre das Gerät 50 Euro teurer ohne diese Mängel dann wäre es echt Super.

Meh, it’s just decently ok. The pins are super cheap and the nut loosen with any form of movement . Started to rust within a couple of weeks. I guess it served it purpose until I can buy something better.

Overall, it's built okay. The problem I have is the false advertising that it will hold 800 lb. 800 lb of what? And the noted cubic feet at 3.5 can't be right either. How do I know? Because I bought eight bags of concrete of 0.45 cubic foot per bag at 60 lb per bag. It took five bags barely. That's a total of 360 lb and by the math almost a whole cubic foot less than what it says it is.. and the sleeves and shafts for the three-point connections are very weak and small so I cut some 1-in diameter pipe and made double sleeves. Again, it's just okay but certainly not as advertised.

Buyer beware top and bottom mounting tab holes are not in line causing box to hang at an angle center line of holes is off more than 1 1/2 inches. Receiver is welded to the bottom of the box and not reinforced, if you attempt to pull anything of any weight bottom of box bends from the stress. I attempted to work with Vevor's technical team several times to come to a solution and their response was that the box is to specification and is within intended design. They also eluded it was my tractor and I needed to make an adjustment on it, its a John Deere can't get any better than that. Basically the box is made of lightweight steel and poorly constructed would never hold 800 lbs. of anything.

Well, you get what you pay for. The finish is nowhere near how smooth and nice the pictures look. Not sure why they dont use standard pins. I have not installed yet as i may return it. Good luck putting loose sand in it as you will leave a trail where-ever you go. There is about an 1/8 gap at the bottom of the door panel so your sand will not stay in the box. Overall finish is marginal at best. Mine looks like the whole top rim was full of rust when they painted over it, so all bubbly under the paint. I expect it to start chipping and looking even worse in the first week of use. I would not recommend unless you dont care how it looks. Putting it on a new tractor seems it will devalue my tractor. I have purchased things from Vevor before that were good quality. This is just not even close.

Not happy that it dose not fit as described

Broke in 5 mints of using it... went to move my log splitter thats only 300 pounds. Start ripping the recver out. This thing is made outta paper

This isn't a Catagory 1 box, it's Catagory 0. It is not for for use, Vevor should be ashamed of themselves for selling this pile of junk! Didn't want to do a return when I asked for one. If you are looking for a ballast box go elsewhere, this is a waste of time and money!

I purchased this ballast box due to the advertisement stating it was for Category 1, but the pins sent with the box are category 0. I sent an email to VEVOR about this, and they offered to send a set of bushings. I replied to them that "bushings will not correct the problem", and told them, "It needed the correct category 1 pins and the attachment holes enlarged to accept those pins. They replied that they would refund me $37 to cover the cost of the pins. It did not cover the cost of what it took to drill the holes larger, buy Quick Hitch Bushings or any other tools, equipment needed to make it a category 1 hitch. So, with that being said, do not believe the description that you see when looking at this box to purchase. It is very misleading. I do not believe that it will hold the 800 pounds as advertised either. The price is what catches your attention along with the description, but beware, it is a different story when you actually have it onsite. Vevor, I'm sorry for this review, but tell the truth when advertising products. I am not very happy with companies that sell foreign made products cheaply with possible false advertising. You can do better!