Kundeanmeldelser for VEVOR Lageravtrekkersett, 14-delers lagerseparator med 5 tonns kapasitet, Demonteringssett for pinjonghjullager med 50 mm og 70 mm kjever, Lageravtrekkersett, Ekstra kraftig lagersplitterverktøysett med koffert

Très bon outil, robuste et polyvalent avec les deux types de mâchoires et les rallonges. Bon rapport qualité/prix. Je recommande.

Toimiva ulosvedinsarja. Vaihteiston laakerit irtosi ihan kohtuudella. Kielekkeiden kärkiosan vahvuus voisi olla pienempi jolloin pääsisi laakerin "alle" paremmin.

efficace, permet l'extraction de roulements même grippés sur l'arbre pourrait être encore amélioré en ajoutant une butée en cas d'arbres creux

Bolts bend and one broke off. I have to source some grade 8 bolts from my local hardware store to use on it. Maybe fix the bolt problem and it won't be a bad tool. All this while removing carrier bearings on a 8.8 axle. So no I didn't put to much on it.

Received bearing puller kit with damaged blow molded case. Very low quality I don’t have high hopes for damage free operation.

I bought this item to remove a wheel bearing from the hub. The kit arrived promptly and appeared solid. However, was not up to doing the job, bolts which should pull the jaws of the bearing separator plate are too soft and bent like bananas. I had to use other means to remove the bearing. I am going to buy some high tensile bolts to try next time. But I'm not sure how tough the metal used for the separator plates is.

Brukeren la ikke igjen noen skriftlige kommentarer.

Producto de calidad regular

Purchased this to remove bearing on my driveshaft carrier bearing. Perfect fit looked like it would make it a breeze to get bearing off. But broke on first try. Material is just too soft not hardened.

The push rod is very soft. The point at the end crushed at my first try to remove the bearing of an angle grinder. Then the push rod and the holding rods bent too.