Kundeanmeldelser for VEVOR Blindhullslageravtrekkersett, 16-i-1 innvendig lagerbane og tetningsuttrekkersett, 16 deler glidehammer, pilotinnsats, innvendig lagerfjerningsverktøysett med 10 delte spennhylser og motstag

Got the job done

The small pillars have an extremely difficult time grabbing a hold of a bearing to actually pull it out of place plus the option of what they give you to support. The pole is good in certain applications and very, very bad and other applications in which case you will actually have to find some sort of pipe or something to compensate for the pool device that you’re looking for the smaller, the pillar, the worse that it works, the larger the puller the better that it works, the second smallest puller after two uses was already destroyed

Haven’t used it yet but was not impressed with the condition of the case.Looked like it was picked from garbage. The damage is not from shipping.

Extremely disappointed that such an organisation has no quality control standard on the products they produce. I purchased this item on the 12th August 2026. On the very first use of it (6th September 2026 I discover the Bearing Puller has not been threaded in order for the collets to screw into it. Consequently, it’s totally useless. Unfortunately, for me I have a series of jobs needing to be done and unable to perform them because of this appalling standard of service. I note too that after having brought this problem to their attention they advise they need 48 hours to respond. A total and utter disappointment A

je n ai pas recu le colis ,probleme

After many improvised attempts to remove a bearing from my free hub this tool did it in about 30 seconds. Easy to use. The tools were oily, and the case was not great, but they were very functional.

Advertised as capable of 1/4" bore up to 2"+. Not true. The bore into which I needed to use the tool to extract a bushing was too large for one of the tools, and too small for the next size tool. In other words, the adjustment available from one tool to the next does not cover all possible bore sizes between 1/4" and 2"+ as advertised. I had to grind the oversize tool to fit in the bore where I needed it. Quality is what you would expect for Chinese made tooling; adequate if you don't need precision or intend to use the tool often. Still, after modifying one of the pullers it got the job done.

Des sa réception j'ai essayé d'extraire un roulement dans succès, le premier embout est carrément foiré.. La qualité n'est pas du tout au rendez vous

Could not pull the bearings from a Chevy 14 bolt with this tool it might work on smaller units. Went to a rod throught the housing like old days. Slide hammer would need to be bigger for what I tried to do.

Solo pedí uno me hicieron el lío y al final me cobraron 2 el producto bien , gestión por parte de vevor fatal