Kundeanmeldelser for VEVOR Bremseledningsutvidelsesverktøy, 45 graders enkle, doble og bobleutvidelser for rørstørrelser 3/16", 1/4", 5/16" og 3/8", egnet for mykt metall eller kobberrør

Wrks gd just make sure you don't f**k up the first time had to recut with supplied cutter wrks ok gd product

I have worked in the exhaust business for many years and have used a few tools made to do the expanding job with an impact or Ratchet. This is one of the few that when used properly does a fantastic job. Its well built and durable and at a very good price. You cant go wrong.

Great tool for the price. My only complaint is the bulkiness of this compared to other hydraulic kits. The inserts are quite large, but it still works good.

This is really good for copper but when using stainless steel it doesn't seem to work really good try to use it on stainless steel and it didn't work too good

I bought this primarily for the double flare feature, specifically the 3/8'' tube size and wanted to use it on stainless steel tube. That said, the first time I used it the 3/8'' tube just pushed right out of the holding die and didn't produce a double flare at all, just a single flare with a small double edge. Frustrated, I tried it again with the tube protruding further from the die, thinking I just hadn't had it tight enough or the tube wasn't far enough forward. Same result, and this time I'd marked the tube and could see how much it had pushed back out of the die. To make a long story shorter, I put the two die halves into my mill and removed .008'' from each mating face and now it works correctly. I didn't think that should have been needed, but it was, at least for the 3/8'' die set. I haven't used any of the other die sets yet so don't know if this is going to be needed on those as well, we'll see. Anyway, all the dies and the corresponding flare mating tools are in the kit, maybe it needs to be fine tuned a bit, but the price is right, the hydraulic part works really easily and I'm happy, lots of stuff you buy nowadays doesn't even work; all the parts are here, it just needs a little finessing.

The hydraulic pump is a little small takes a little bit of muscle to make it work. I just use my bigger hydraulic pump to get the job done. Used for exhaust work.

Good tool with lots of dies. It's a bit awkward to use and not good for tight places, but it will do a very nice repeatable flare. I'm happy with the purchase.

Toimiva ja kestikin putkiston tekoa. Kumirinkulat mitkä pitää leuat nipussa katkeaa helposti.28mm paineilma hylsyn vain piti ostaa lisäksi. Yksi putkisto tehty joten pidempää kokemusta ei ole mutta ihan ok.

It would be way better but I just seen it on sale for $200. I paid 322 for it. It works as it should. The hydraulic pump is a little small takes a little bit of muscle to make it work. I just use my porta power pump to get the job done.

Die housing broke second Time i use it but replacement come fast. Good price,fast shipping and customer service is awesome.