Kundeanmeldelser for VEVOR Skuffetannstang, 72'', Kraftig traktorskuffe med 9 tenner for lastertraktor, kompaktlaster, 4560 lbs lastekapasitet, bolt-på-design, for effektiv jordgraving og skuffebeskyttelse

Definitely I must have for a tractor that has a smooth cutting edge. Totally game changer from breaking up the Earth. I put it on a 32 hp tractor and it broke up old stone in the driveway, and graded down some land that I needed done around the house. I don’t really like the set screws because they get full of dirt, but if you take a piece of tape and shove in the hole, then you have no problem pulling the tape out and get your wrench into the set screw to take the teeth off. my bucket had holes already in it of course, the flat bar holes did not match up so I had to drill new holes in the tooth bar, which is not a big deal if you are familiar with hand tools. All in all I say get it, you will not regret it. And the quality of the product seems very well. Vevor does not have replaceable teeth, but you can find them online. There is a part number on the tooth.

I welded it on,,it is as strong as anything made for 1000 dollars,my bolt holes didn't line up ,but I would rather weld it anyways because I am rough on my buckets

Works great for loosening dirt. Easy to install and remove. I plan to use it to build a small pond with my tractor.

Nice piece of hardware for my tractor. Nice piece of hardware for my tractor. Nice piece of hardware for my tractor.

good product, unfortunately one of the teeth was missing its retaining pins. never fitted

I bought the tooth bar a couple of weeks ago for my 72" skid steer bucket. The holes don't line up. The tooth bar will not clamp on. When you tighten the clamps it pushes the bar off the bucket. It's still out on the ground. Haven't been able to use it. Not impressed.

broke a tooth off already. advert is misleading saying its heavy duty on website, but in the manual for the teeth it claims to be a for debris. teeth bend easily and weak points due to set screw location in cricital stress area (hence the broken tooth and others with similar outcomes) maybe worth it if you don't expect much out of this

the bar is pretty heavy built and it performed well for 2-4 months then it lost a tooth then not long after that a bolt sheared and i couldnt see it and bent the bar in a way it couldn't be straightened. in all fairnessit did see lots of abuse digging into really hard clay several hours a day.

soft steel , two teeth already broken , air bubbles in casting where teeth broke ... no strenght ..

Good concept but the casting very bad. I had one tooth adapter snap and it was like sand inside. Vevor will replace eventually, at least 6 or more contacts but if you persist they will give in.