Kundeanmeldelser for VEVOR støpt stålambolt, 60 kg ambolt i ett horn med stor benkeplate og stabil base, robust rund hornambolt med høy hardhet, smed, for bøying og forming

Livraison rapide et bien emballé dans une caisse en bois et huilé en surface. Quelques finitions de moulage apparentes mais rien qui n'empêche une utilisation normal. Produit de très bonne fabrication pour un prix très compétitif.

little expensive for a hunk of iron

Did the job. Used it to hammer flat and put edges back in pressed metal items. Cheaper and handier than buying a thick block of solid bar.

I like this small anvil. It does what I need as I do not do any heavy anvil work

It is well worth the money, once I received it. Apparently, there is some kind of problem when ordering it through Amazon. Twice it made it to within 70 miles of me and then returned, "Undeliverable". I haven't a clue what the problem was, but when I ordered direct from Vevor, I received it within 3 days. Quality piece for the money. 5 layers of 2 x lumber and short 4x4 legs gives it a good solid base, with no vibration, but plenty of rebound. Thanks.

L'incudine fa il suo, non ho riscontrato difetti, danni o altro. Fissata già sul suo supporto e pronta all'uso. Unico neo l'imballaggio. Un incudine di 40 kg inserita in una scatola di cartone di dimensione più grande del prodotto con semplicemente due pezzi di compensato sottile messi a "protezione" laterale delle due punte e delle fascette per tenere assieme tutto che ovviamente con il trasporto e movimentazione si è distrutta. La foto rappresenta il pacco nel momento della consegna.

Impeccable Super rapport qualité prix Conforme à la commande Je suis ravi

Mine got beaten to hell in shipping. It was sticking out of the side of its all but shattered box when I got it. Some rust and a chipped end, but all of that was almost certainly the delivery folks hating a heavy box. I did find used anvils of higher quality and similar price locally after the fact, and found it at a lower price than on the vevor site later as well so that was a bummer. So maybe shop around a bit. It's perfectly serviceable from my unskilled perspective though. I got it to learn a little smithing so my opinion on quality isn't the most reliable. But by my estimate it tested at about 70 or 80% of the ball bearing bounce height a blindingly expensive anvil produced at literally a tenth of the cost. So I'm still perfectly content and won't ship it back even with its damage it incurred.

Receive the annual package very well for the cost I was not expecting a whole lot. I knew it would do what I wanted it to do. I was pleasantly surprised to find the hardness very acceptable for the entry price level. I did not check it with the ball bearing, but my 22 ounce ball pan hammer bounces really well. I did knock a little bit down on the quality because the Hardy hole is really not straight. it’s kind of taper, which is really not a problem. I have not found any defects. I’ve only used it two or three times so far and it has held up very well under hot steel while I’m pounding it overall I would give it a 97 because of the price.

This is a great anvil for the money. While all the local antique dealers have been watching too much Forged in Fire causing the price of used anvils to skyrocket to well above the fair price. I was skeptical at first but it really is a great anvil. I can find no faults with it whatsoever.