Kundeanmeldelser for VEVOR dypbrønnspumpe, 550 W utgangseffekt, 230 V, 65 l/min strømning 210 fot trykkhøyde, med 65,62 fot ledning ekstern kontrollboks, vannpumpe i rustfritt stål, for industriell vanning og hjemmebruk, IP68

pompe de très bonne qualitée ! Fonctionne à merveille ( puits à 25m de profondeur ) très bonne pression de sortie ! Je recommande

Es impresionante la potencia de extracción de agua en un pozo de más de 20 metros de profundidad. La instalación es muy sencilla y la desconexión automática incluida en la bomba es muy práctica y facilita mucho dicha instalación. La verdad es que al recibir el producto no daba crédito a que me hubiera costado el precio que pagué.

Works great! Took the motor off and it hooked directly up to my fountain. Pond never looked better!

Bought this pump to use the motor on a pond fountain. It hooked up perfectly to the spray nozzle. Works well! I’ll be buying another one for the second fountain…😊

Compré este conjunto de bomba y aparato de presión. El aparato de presión no lo he instalado. La duda es, solo con la bomba la puedo dejar encendida y se conectará tan sol cuando abra el grifo o sin el aparato de presión no se para sola cuando no haya grifo abierto?. Gracias

This review is for the 1HP, 750W, 115V VEVOR deep well submersible pump. I use the pump vertically in a 30 foot, hand dug well so relatively shallow. The line was kept at 1 ¼” with Vinylite G911 tubing and stainless fittings. After about running the pump for maybe 20 hours over this past summer, I am very happy with the performance and output. Since I am in an off-grid situation, I rely on a solar-battery system with a back-up generator. During start-up, my 2,000 watt invertor (4,000 W peak) wasn’t able to run the start-up phase but another 3500W inverter worked well. Off grid users should be aware of this limitation when deciding on a pump motor size for their system. My Honda 2200W inverter/generator was also able to run the pump but I doubt it would power a 1.5 HP unit, again, because of the start-up requirement. The attached photos show the install, examples of output with a 2” fire nozzle and large sprinkler, and pressure measurements with both full open and full closed line, the latter measured at about 75psi. The full-flow, open output pressure of about 25 PSI may limit the operation of some sprinkler devices but with my large nozzle, I could send a water stream about 60 feet – very useful for fire control. I estimate that the pump could produce about 5,000 litres per hour at full flow from a water depth of 25 feet. Another important feature that the user will have to consider is that the pump has no automatic pressure cut-off switch. If the user is only using it in just an on-off scenario this doesn’t matter but the pump is not designed to operate without flow due to overheating issues. Next summer, I’ll experiment with a pressure cut-off switch or pressure tank. I would recommend this pump for quality, performance and especially value.

Sono soddisfatto la stò usando funziona benissimo facile da istallare comandi e schema facili buon prezzo ottima qualità la consiglio

Installata a una profondità di 20 metri e con la fontana distante altri 20 svolge egregiamente il suo lavoro. Abbinata ad un pressostato si attacca appena si apre il rubinetto ed ha un'ottima resa, con una bella gittata. Vediamo nel tempo quale sarà la sua durata. Per ora pienamente soddisfatto dell'acquisto

Pump is very powerful with only 500W pump can reach high pressure works ok. In packet icnluded good rope and cable is 20 m. Pump is small dimension. Packet is great.

Bonjour, Installée par un plombier en retraite, convient très bien à mes besoins.