Kundeanmeldelser for VEVOR kjernebormaskin 0,8-7,1 tommer Ø 2600W håndholdt og stativ kjerneborrigg

Moyen gamme voir bas de gamme, manette dur à faire avancer et recule Châssis fixe

livré en retard

I needed to drill 1 4" hole for a dryer vent.. 8 inch of conrete 5 hours latter i finished the hole with a chisel and hammer. the drill is way to fast for a 4" bit.. like double the RPM. a 4inch bit should be run around 600, this drill when i put a rpm meter light on it was spinning at 1200 on its lowest setting. So it just glazes the bit... after having to dress the bit twice I figured out you need to keep feathering the trigger to keep the RPM low. now the drill otherwise did ok. it doesn't like running hot and at it popped a connector inside that i had to take the drill apart to re attach. after securing it properly wit wasn't an issue. it also leaks water around the fitting on the collar while operating, not the end of the world but it does make a mess outside of your hole. The bit is an absolute POS. The "diamond" is a very thin coating that is gone 4 inches in the concrete, so your basically drilling with just steel , pray you don't hit rebar. it also doesn't drill a 4 inch hole it drills a 3.93 hole (100mm) that a NA dryer vent doesn't fit into without modifing it. which is the true feeling of utter defeat after spending that much time slogging it out behind the handles of the drill So if you are doing 2-3 inch holes.. buy this drill, without the cheap vevor bit. then buy a decent bit that has a NA brand name on it, you should be fine

Alles wie beschrieben, funktioniert einwandfrei. Konnte für die geplanten Zwecke gut eingesetzt werden.

Maschine ausschließlich im Bohrständer zu verwenden! Keine Rutschkupplung was bei Bohrkronen gefährlich ist, sehr hohes Verletzungsrisiko. Die Maschine zieht durch bis sie durchbrennt Mit 80mm Bohrkrone ist der Ständer einigermaßen nutzbar, wenn sich eine Größer Bohrkrone verkeilt wird einem Der Ständer um die Ohren fliegen. Wer nur wenige kleine Löcher Bohren muss und sich dafür Zeiiiiit lassen kann ist die Maschine i.O.

Não comprem não serve para nada...

machine dangereuse

UPS hasn't picked up the package yet because you haven't ordered a courier. This has been going on for two days now—what is the problem?

No me ha gustado nada, es muy peligroso de ninguna forma se puede usar sin plataforma y lo venden para usar a mano. No tiene embrague y en mi cas me he lesionado la muñeca. No me parece lógico a estas alturas que se venda un producto así para usar sin plataforma. Lamentable

Richtig schlecht leider