Kundeanmeldelser for VEVOR 305 mm betongsag, skjærekutter, belegningskutter, betongkutter 2800 W

The saw comes with two brass ball valves, one of which sheared off when I hand-tightened it, and a water pump which does not fit Australian outlets. There were no assembly instructions, and usage instructions were difficult to follow. After some re-plumbing using Stefani water filter parts and garden hose connections I was up-and running. It is essential to run this saw with water but saws of this diameter are prone to kick-back and need very careful handling, (mine has a 2200W motor). For prolonged cutting I would recommend having workshop vacc running to keep the water levels down. The blade has a slow start (good) but also a slow stop (not good for safety). For stability and avoiding kick-backs I found it best to work towards my body, whilst keeping out of the direct path, given the above dangers. It cuts well through concrete and reo but it is best to let it drop into the cut under its own weight and not force it in any way. For safety I would have preferred a trolley attachment to guide the saw. Overall, the water attachments are poor quality but once resolved the saw is powerful and works well, albeit needing great care when using, from a safety point of view.

Very good saw, so far we are very happy. .

Over all Its a nice unit to have for the price. We were inside a store and dust and gas fumes were not an option. The pump and water helped this condition a lot. The job was - We had to make about 80 feet of cuts through 5" concrete with wire to replace a bad waste line. It did the job the only big complaint is that it will pop your 20 Amp breaker often. So what I did was installed a 30 amp breaker on the panel and made a custom 10/3 cord. We can use this set up any time we run the saw. Best not to try and go more than a 25 to 50 foot cord as there will be a heavy draw on the saw. If you go with there smaller units maybe the breaker pop issue is not a factor? Im on my 3 Vevor tool and so far so good. Way better than Harbor Freight stuff.

The saw worked great. Not quite as powerfull as I was hopping but worked fine. After a couple of days, the trigger lock started getting stuck a bit. But otherwise works well.

The saw is great to work with and so far no issues with it. The included pump can overheat so turn it off when not using the saw or the valve is closed. If you are cutting pavers greater than 3.5 inches you will need to flip it but it still cut straight and clean. Overall it is great.

Utilisée pour couper des dalles en grès cérame de 2 cm. Résultat décevant. Il faut insister et la dalle finit par casser. Je pense que le problème vient d'une lame de mauvaise qualité.

I have received it

Water valve showed up broken, didn't know until I went to use it(4 days later) and now I have to wait for somebody to decide if I will be getting a warranty part? Seems pretty silly

Bonjour, aucune notice en d autres langues que l anglais et le bouton avec le ressort pour bloquer le disque ne tiens plus en place a peine appuyer une fois dessus Cdt

Did not manage to use it for my project, low power could not cut my concrete driveway.Also after running it for about 45 seconds consecutively, the inline breaker trips.