Kundeanmeldelser for VEVOR 16"/40,6 cm elektrisk betongsag våt-/tørrsag med vannpumpe og blad

Lo vi lo compré , me pareció un precio razonable y puedo decir que funciona perfectamente.

The 16 inch saw certainly pulls more than 15 amps. The NEMA 5-15p is only rated for 15 amps. This saw also pulls more than 20 amps. It may work on a generator like this. If you plug it into your house wiring the breaker will eventually trip. It won't short trip your breaker, but it will heat the breaker and trip it. You can take frequent breaks and it will allow your breaker to cool. Regardless this is all a bit sketchy and the 16 inch saw should have come with a 30 amp rated plug. The NEMA 5-30 would be an obvious choice for code compliance. Although it's uncommon. A travel trailer 30 amp plug would also be safe and many generators could support that, but that's supposed to be used for travel trailers only. I may swap that plug at some point.

I purchased this to cut out a portion of the driveway that had lifted and created a lip. Received the order quickly and assembly was easy. You will need a circuit large enough to handle the amps or it will trip. Saw cut easily through 4-5” concrete. The only issues that I had were the pump for the water kept floating upa in the bucket that supplies water and There was an issue with the two small brackets that hold the guide on being bent. I straightened them out with some pliers, but feel they are compromised now. few spot welds should fix that issue. I contacted VEVOR and they came up with a satisfactory solution. I would buy this again.

Works really well. The only problem it spins in reverse. So if it gets jammed, it will kick up towards you. Be wary!

It works

My first thought was how much this saw sucks. I was running it off a generator with 20 amp service but it kept tripping the breaker and lugging. After running a 30 amp outlet and 10 gauge extension cable it was much much better. Key thing to note is concrete is hard and attempting to cut through a slab takes many passes. Once you have that I. Your head this thing works great. I did about 100 feet of cut at 4" depth and the blade is still fine. It took about 8 hours all together.

It’s an overall good saw for the price. It gets the job done. The biggest knock I have on it is the pump that comes with it. Died first use so I had to refit to accept a connection to a hose and use clamps to strengthen all the tubing connections as the pressure made the lines pop off. If the saw came like this with no pump I’d give it five stars.

Works just fine. Use better hose clamps, tends to be leaky. Cuts just fine. Use 20amp cord and circuit VIP!

Did the job I needed it for I used water even knowing it was a dry blade just to keep dust down. Make sure you use a heave cord. On 20 amp breaker. Better performance than my smaller one. Thanks

Good saw for cheap price, only down side is you have to go slow otherwise your 15 amps breaker will trip. It need a 30 amps breaker if you want to go full cut…soft start work great on it