Kundeanmeldelser for VEVOR elektrisk rørbøyemaskin, 750W elektrisk rørbøyer med 6L hydraulisk sylinder, bevegelig rørbøyemaskin med 3 matriser og 180° maks bøyevinkel, egnet for rør på 25,4 mm, 38,2 mm, 42 mm

read full review before buying we had to do a lot of mods My shop bends about 30-50 tubes a day with offsets, kicks and 90’s from 1/4” to 1 1/2”. now this bender does bend fast and the auto setting is decent. Our struggles with this bender is 1: the frame is very wide compared to our other benders. If you have very close 90’s you will have to reverse bend every time. 2: The die clamp that holds the tubing down while bending, some of them don’t fit and you have to modify them by re-welding them. 3: The die clamps that hold the tubes if it is too big and not snug that will effect your degree bends, in some instances by 20 degrees 4: There are cheap contractor coils inside the cabinet that will arch every time you start a bend once. 5: All Bending dies Have “no markings “ on them so you will have to mark you 0, 15, 30, 45, 60, exc… 6: This bender does feed tubes in from the left side so if your used to the standard right to left feed you will need to adjust. 7:frame with dies are 600 pounds. very heavy we put wheels on ours. 8: this bender is 3 phase 220v make sure you have it or you will need a cps or vfd phase shifter from vevor 9: we run ours of shop 220 and off a generator when traveling with the cps phase shifter.