Kundeanmeldelser for VEVOR 1800 W bordsag elektrisk skjæremaskin, 625 mm skjærekapasitet, 4400 o/min, 85 mm 90° tverrsag og 60 mm 45° skråsnitt for tre, snekring og innendørs/utendørs verksted

diese ist nun die zweite gekaufte Säge dieser Art von Vevor. Es ist mir bis heute nicht gelungen für die erste Säge 2 Kohlebürsten zu kaufen. Somit musste ich um mein Projekt fertig zu stellen eine zweite komplette Säge dieser Art in der CSSR kaufen. Ich hoffe auf eine Resonanz von Vevor. Viele Grüße aus Berlin [email protected] Wilfried Berke

The saw body is made from cheap plastic material, making it difficult to assemble and leaving one to wonder how well it will hold up over time. But even worse is the fence design. As it travels across the table it falls into the channel used for the slide. Absolutely inexcusable.

Beim Erstlauf dachte ich, das Ding ist kaputt! Solch ein metallisches lautes querzendes Geräusch des Motor. Hingeschaut, ja der Motor sprüht Funken. Klasse, was ein Feuerwerk.... Wäre Gas im Raum gewesen, das Wäre es gewesen! Nach ca 20 Minuten des Laufens wurde die Funken weniger und das metallische Geräusch leiser. Die Säge ist robust, scharf, leicht; Aber sicherlich keine Säge für professionelle Handwerker, die damit ihr Einkommen bestreiten müssen. Ich nutze die Säge um Anzündholz abzulängen. Das kann die Säge.

there is too much plastic on this saw, feels like it won't hold up or hold true to settings with all the plastic pieces

Unfortunately this saw isn’t up to the standards. Used it once ,soft pine and immediately stopped working after the first cut which wasn’t completely done. I have products from this company and they work welll and hold up well. But unfortunately this product doesn't hold up .

Ok, I fully understand a table saw under 250 is not going to be the best quality but this is not worth 100. It is not accurate at all. When you lock the blade in at zero degrees you can push on the full blade assembly and it moves over a couple degrees, not the blade, the whole assembly. It is mounted on plastic so that is why it gives. This will be fine for rough framing work e.g. like plywood ripping but ripping molding or finish work expect a lot of uneven edges. I will probably give it to one of my guys on the jobsite for rough work but do yourself a favor and buy something a little higher quality.

Ordered online and received two saws vice one. After several attempts I finally got customer service. Was told to keep saw and would be given $30. Finally after several hours I was told I would be refunded $197 and keep second saw. I gave up and gave to a friend. I had paid over $330 and didn’t need second saw. I will not deal with company again