Kundeanmeldelser for VEVOR Elektrisk Vinsj ATV UTV 2041,2 kg Syntetisk Tau Vanntett Fjernkontroll

Very good and east to use

Il verricello e come da descrizione.. purtroppo l'ho usato poco quindi non so dare precisamente un voto..ma visto il prezzo il suo.. è il secondo che prendo perché il primo si è rotto il meccanismo dopo un po'..questo va un po' più piano ma speriamo duri di più..comunque qualità prezzo do un 7/8

Bytte bara ut en trasig vinsch på min atv så använder inte kablage som följer med. Inte använt den så mycket ännu men den verkar robust och bra hittills.

The winch was perfect to pull out tree stumps, it is quite small but is well made and hefty for its size, Hooked it up to a small spare car battery and it pulled the stump out with ease. Have not used the remote control, only the manual switch to operate it. Not sure what other uses to put it to at the moment, but it I am sure it will be useful in the future.

Je les installer sur mon porte voiture et j'ai déjà chargé plusieurs voitures avec dons 1 partner de 1t300 avec les roue dégonflé 😅 pas rapide mes efficace la télécommande a une bonne porté la corde et solides

Dear All, We are drone and Launcher producer. For our Launcher we need electrical Winch like 3500 is. The remote controlee is not professional, can we get similar like below in the picture. Now we are in the test period if the test pass than we will need 100 pcs per year. Please for Answer ElevonX d.o.o. Predilniska cesta 16, 4290 TRZIC www.elevonx.com Best regards Tomaz +386 31 339 785

This unit worked great with the snow plow but got stuck and the unit seized under heavy load. Contacted vevor and they sent a new unit. Will continue to use their products.

Verricello di buona qualità, peccato abbia solo 1 telecomando e non abbia la staffa per il fissaggio. Inoltre la spedizione è risultata un po' lenta.

Kom hurtigt. Nem at installere og fungere upåklageligt. Kræver dog afdækning og bør korrisionbeskyttes.

Purchased this winch to replace a 20-year old winch for my ATV. It’s used primarily to lift a snow blade. Installation was pretty straightforward. I did have to cut and re-splice the harness going to the up/down switch so I could route the harness correctly. Only negative about this which is that none of the wires going into the controller box were sealed. I applied clear silicone around the wires to help prevent moisture from getting in the controller box.