Kundeanmeldelser for VEVOR motorstativ, 1300 LBS roterende motorstativ med 360 graders justerbart hode, motorblokkstativ i stål med brett, 4 hjul, 4 justerbare armer, for vedlikehold av kjøretøy

Works well for the 5.4 fords we are doing so many of. Stows away nicely and works fine.......................................................................................................................................................................................................................................

I used it for a flat 4 cylinder, 2.1 liter aluminum engine. Works very well, just put a little grease on the pivot.

Works perfect for what I’m needing to do. Not only this time, but hopefully in the next few months, I will be getting another motor to put on it.

Matériel pas encore utilisé, mais semble plutôt robuste. Equilibre à tester avec charge d'un moteur...

The engine stand is well-built, easy to assemble, and priced well. I have used others and they were cheaply built. The wheels on this product work better than most of the engine stands I have used before. I'd recommend this to anyone that asks.

Good overall but hard to get the pin back in when you rotate it but still a good buy

sturdy enough for my 3uzfe "old lexus v8" but its only about 430-480 lbs tops, and its drooping a little , wouldn't put anything heavier than that . granted it was cheap but it would never hold 1500lbs safely doing the job for now ,but wish i spent a little more on a better one

The engine stand was reasonably easy to put together, it's a decent design but the execution leaves something to be desired. The plate that the black arms bolt to was welded to the black cylinder slightly clocked, and the hole in the orange cylinder that it slides into was also slightly clocked, so the plate is quite angled when the pin is inserted. The picture shows how tilted the plate is when it's supposed to be horizontal. I can compensate for it somewhat by adjusting the arms, but it's still a bit annoying. Also, after rotating the engine, the pin is difficult to install again, the holes don't line up really well along the axis of rotation. Probably why the price was so good.

Works like it should.It's hold the motor right now.So far about a week or two?Haven't got to it yet.I'll let you know how it performs in the end

This is a great engine stand fit perfect in my shop. We’ll buy another one if I need it.