Kundeanmeldelser for VEVOR Kranverktøy HVAC, 45° eksentrisk enkeltkranverktøy for 1/4"-3/4" og 6-19 mm kobber-aluminiumsrør - med metriske og SAE-klemmer, rørkutter og verktøykasse for reparasjon av kjøle-klimaanlegg

Livraison rapide

Fonctionne très bien, veiller à bien ébavurer en amont et derrière tout se fait parfaitement, comme visible sur les photos deux dudgeons en 3/8 sur du cuivre.

una herramienta espectacular para climatización

Livraison très rapide et conforme à la commande. Emballage soigné et matériel reçu en bon état. Notice uniquement en anglais. Outil non encore utilisé.

Not bad, flared well and easily on 20mm annealed copper pipe. Good tool to have on hand.

Tal como indica en la descripción

conforme, boîte complète, semble solide et de bonne qualité, peut-être un regret car pas pince pour le 3/16"

I bought a mini split a/c for my garage, but I ended up kinking the 1/2" line while trying to run the line through the attic, to fix it, I cut out the kink, and I bought a couple couplers but I needed to flare the new copper line ends, I picked this flare tool up and it did the job perfectly, mind you I have never flared a copper line ever in my life, and the end result was as professional as it gets, so much so I had to take a picture of it, and after the repair there were no leaks!

Purchased the copper line flaring tool ,worked a treat ,doubled flar easy as ! Worked perfectly set up correctly

I have, this flaring tool to make both ISO and SAE flares on CuNi tubing. The flares did not come out when first tried. I did find the problem.... The rotating flare set did not sit down on the clamp. This mis-aligned the die. After some "fiddling" it seated, fixing the problem. Tool is easy to use and produces good results. It is very intuitive to use, which is good as the directions for use are at best "iffy". I am confident it will do the job for which it was purchased.