Kundeanmeldelser for VEVOR Bensindrevet stangsag, 43CC 2-takts bensindrevet stangsag med 25,4 cm skjærestang, batteridrevet tretrimmer med roterbart hode, 2,1 til 3,6 m uttrekkbar, kraftig motorsag for trebeskjæring og beskjæring

excellent value for money does the job perfectly

All Good

ok vare

Great Value. Easy to use. Delivery was one time.

Honestly really happy with this pole saw. wasn't sure if it would be good quality, but it has impressed me. quality is better than i thought. just had to tighten the screws on the handle. The pull start has a unique windup that makes it really easy to start. It is a little bit heavy, and the extra extension poles to bog down some of the power. The clip/ attachment system to extent the poles could use some improvment, but it does work good. I wish i got the multitool version instead of just the pole saw but they were sold out. I wish they sold the attachments separately,

Habe bereits 2-3 Stunden damit gearbeitet. Motor ist gut gestartet und hat ausreichend Leistung. Bin zufrieden damit.

Teszi a dolgát Egy pár csavar hiányzott azt potoltam

Startet lett og går fint. Det gjenstår å teste den på tyngre oppgaver.

Franchement top El coupe très bien j’en suis satisfait je la trouve pas si lourde que sa . Je la recommande

Assembly was difficult. Whilst the extension poles would easily click together (into each other) none of them would fully click into the first (engine) pole. The inner shaft of the first pole was about 7mm too proud (recessed by about 17mm instead of about 24mm) preventing another pole from being fully engaged. Dismantling the motor end of this pole and reseating the inner shaft fixed the issue. On first attempt the engine was difficult to start. Locking the throttle lever in the fast idle position didn't seem to do anything. By looking through the slots on the engine cover I could see that the throttle lever was not actually moving the lever on the carburettor. Dismantling the handle, I found that the throttle cable was not engaged in the throttle lever. I corrected this and was able to start the engine. Both these problems were on parts that were already assembled before delivery so poor quality control. The saw functions as it should and does the job.