Kundeanmeldelser for VEVOR papirkutter 12" A4 giljotiner papirtrimmer 400 ark kapasitet metallbase

First the safety pin is not working, to short. Next when cutting the blade pulling the paper so it is not align anymore and the top paper is folding and punch, the bottom paper is not cut all the way thrue. So imo it's not worth the money.

The quality is bad. it does not cut at all on the edges ... inspite of bringing down the blade multiple times... Pls do not buy

Bought it for my wife and it doesn’t make straight cuts, the red striking plate sticks up past the deck so you have to lift whatever you cut over it, the plastic alignment arm doesn’t line up with the lines on the deck and every time you cut more than one sheet the blade forces all of the sheets to move closer to the other crooked arm that the plastic alignment arm is attached too, will be figuring out how to return this item

Não gostei nada do produto, pois não atende as minhas necessidades. A base aonde serve de trabalho para o papel não é como a da foto é um ferro com íman que não trás nenhuma estabilidade. A linha de guia de corte mal se vê. Produto extremamente caro para o que ele oferece.

The tracking device is not the same as what you see on the website. Instead, it is a big magnet that keeps moving while trying to get precise measurements. Had I known, I would have bought something else that gave me more precision. It does cut through a lot of paper though. Then again, the safety device that keeps the handle in the air is not doing its job of blocking the handle from falling. Lower quality than expected.

Within 2x use the blade was blunt, the black plastic calibration bar wiggles 5mm in all directions so cutting is also very vague.

Der Artikel ist schlecht. Schneidet schief und die Fixierung fürs Papier macht schreckliche Abdrücke. Leider sieht sich der Kundendienst nicht in der Pflicht erreichbar zu sein. NUR KI Antworten.

I am very disappointed in this product! It has been delivered not as shown. It does not have an adjustable, locking paper bar as shown in the picture. Instead, it has a plastic angle with round magnets on one side to attached to the base of the cutter. This angle will easily move allowing paper to be cut at different unintended lengths

The product I received does not match what was advertised. Several components are inferior—for example, instead of a fixed bar to stabilise the paper, it uses a magnetised bar that constantly shifts position. The biggest issue, however, is that it simply DOES NOT CUT PROPERLY. On the rare occasions it does cut, the results are inconsistent and it often fails to cut through the entire stack of paper. What makes this even more frustrating is that the product arrived with a sticker stating it had been tested at the factory. Given that it does not function correctly out of the box, that claim is difficult to believe. A product like this should arrive ready to use and perform its basic function without requiring manual adjustments. Instead, I had to hunt down a vendor video to find adjustment instructions, as no assembly instructions or instruction on how to adjust it was included in the box. Even after following those adjustments, the cutting performance remained poor and inconsistent. Save yourself the frustration and don't waste your time on this product. I will be seeking a refund.

About the only positive thing I can say right now, is it came a day earlier than expected. The first confusing thing is the version that shipped is not the one you see online. The paper alignment bar is magnetic and it difficult to get straight on the ruler lines. I could figure out how to assemble it, but it's confusing at first. Once I stated using it, the magnetic paper alignment bar can move slightly. Next, the pressure bar that holds the paper during cutting leaves an indentation on the good side of the paper you're cutting – so the waste side actually turns out better. The instructions are so basic and there aren't any tips. It will cut through large stacks of paper but count on some being damaged in the process. I would give it more stars if it didn't smash the corner of the paper, or if there was a way to avoid it.