Kundeanmeldelser for VEVOR høytrykkskompressor, 4500PSI/30MPA høytrykksluftkompressor, 1800W 220V automatisk trykkavlastende luftgeværkompressor egnet for paintball-luftgevær, PCP-gevær, dykkerflaske

Necesito saber cuándo llega mi pedido que llevamos viernes sábado y hoy lunes sin poder movernos

So far so good. I used it once and it works fine. Strong fans and relatively cool operating temperatures.

Erg blij met deze compressor! Werkt perfect! En zeer betaalbaar.

pumpt schneller auf wie gedacht ,preis geht ca 250€ ist etwas schwer ,macht ein guten job

Reçu le produit rapidement et surtout un envoi très soigné. Le produit est parfait il fonctionne à merveille. Rien à redire.

best bang for your buck

Buen producto

Arrivato oggi 26/07/2026 ,provato subito sulla mia Kricket II , per portare il serbatoio della carabina da 100bar a 270bar ha impiegato meno 5 minuti funziona molto bene anche l'auto spengimento impostanto sul manometro, per il momento ho potuto notare che la ventola del raffreddamento fa molto rumore , ma penso sia normale, unico vero difetto che ho trovato, che qando è in funzione virbra molto e in appoggi sul pavimento tende a spostarsi talmente tanto che è probabile che tiri a terra la carabina . Per il resto funziona alla grande

hmm where do I start, its a very capable compressor there are a few things I dont like that much. Instead of the adjustable pressure stop known from other brands this compressor uses a safety valve that "should" open around 4500 PSI. It does that when I tested it with a plugged filter with the pressure raising very quickly. BUT once connected to a bottle, the pressure increases of course way way slower and because of that the safety valve does NOT open reliable, I was close to 4800PSI in the bottle already when I had to shut it off manually. So the valve works in a test scenario when you plug it and the pressure increases quickly but does not work reliable when you actually filling a bottle. Direct filling a PCP gun bottle is also not possible as you cannot set a pressure so you have to fill a bottle first and feed it from there to the PCP gun or you constantly stay close and stop the kompressor as soon you reach the needed pressure. You also need to cycle the pump with cheaper oil and no load like 4-5 times until the oil stays clean. Used expensive oil at first try and it turned black after like 10 minutes so make sure to clean it out first with cheap mineral oil and once its clean use the expensive synthetic one. It has an automatic temperature shutoff but it would be nice to also see the temperature as there are no displays on the device. Get a proper filter, best would be a 2 stage, the compressore creates a ton of water and the little filter it comes with will be soaked fully with oil and water after a single use! I upgraded the compressor feet with vibration dampeners as well a more capable waterpump with higher flow. Planing to build a closed loop with 2x240 Heat eschangers and 4 8k 120x30mm server fans.

Le compresseur a cassé après 16 remplissages de bouteilles de 0.8 L. Le SAV a refusé un remplacement ou un remboursement, et m'a envoyé des pièces de rechanges avec lesquelles j'ai effectivement pu réparé. Attention, ça demande un minimum de connaissances techniques et d'outillage. Depuis la réparation, j'ai remplis 11 bouteilles de plus, et tout semble fonctionner normalement. Le compresseur est assez bruyant, pas très rapide, mais le système de refroidissement est vraiment bien conçu, et le compresseur ne chauffe pas. A voir dans la durée donc.