Kundeanmeldelser for VEVOR lærskjæremaskin, 7,1 x 3,9 tommers pregeplate manuell stansemaskin, 0,47 tommer trykkslag lærpregemaskin, doble styreaksler stansemaskin for forskjellige materialer

Funciona perfecta mente, Muyy útil para cortar cuero o cartón donde se requieren muchos cortes iguales venden los moldes en muchas weps

The unit is very nice, it works great! The only issue that I had the female thread on lever bar was bent over, nothing that a small file could not rectify! Stamped out a 4x4 coaster in 8 to 9 ounce veg tan leather, it worked better than I could hope for! I look forward to using this a lot .

presse de confection lourde de très bonne confection. Elle sent la qualité de fabrication. Facile d'utilisation, une fois la presse réglée il est facile de faire des découpes en cuir.

This is a robust and very precise die cutting press. Made out of solid steel parts and both ball bearings are top quality. All metal parts are protected by special powder coatings and machine operates on very simple method. I make professional leather hand bags and leather goods. This cutting press is very useful time saving tools. It will handle even 5-6mm thick veg tan leather if you have decent steel dies. machine is very easy to set up within 30 minutes. Once you have perfect level of true paralel between top plate and the base and than just press the handle down than you have made your perfect cut. I would highly recommend this machine to beginners and professionals. Actual cost of the machine makes it a must in any leather or craft workshop to save you a lot of time and will give you the precision. JuJu Bespoke Hand bags .

I receive the tool quickly and the qualuty of the tool is awesome. Thank you Vevor great price and great service so awesome experience. Thank you

Pretty solid deal for the price but with some drawbacks. Vertical travel is adjustable by working the nuts from under the base plate. The pressure is not uniform because of the enlarged plastic orange plates. Anything directly below the main black pressure plate will emboss fine but outside of that surface, the pressure is less and embossing less pronounced. You can work around this by using a separate hard metal plate added between the orange plastic and your actual embossing dye. The feet have M8 screws so that's what you need if you want to secure it to the work table. Which you should do, because it tends to tip over when pressing. Max width that you can fit between the spring columns is

Works well, but wish there were adjustments availabke

The initial positioning creates an unfavorable angle for the fulcrum, leading to discomfort and potential wrist strain. Also, the gap between the plates could be slightly increased to assist positioning of cutting plate and leather sheet.

La prise en main globale est très facile, la presse est facile d'utilisation. Seul bémol que j'ai rencontré avec mes emporte-pièce : la plaque du dessous en plastique est un peu trop rigide, il faut donc rajouter une matière plus souple en dessous pour que l'emporte pièce coupe bien à travers la matière choisie.

Bonne machine Simple d’utilisation Seul bémol : reçue rouillée