Kundeanmeldelser for VEVOR Lineær aktuator 12V 10In Heavy Duty 1320lbs/6000N 0,19"/s IP44-beskyttelse

Perfetta azienda arriva la merce , con spedizione veloce Consigliata

fungerar mycket bra till mitt ändamål, stak och bra kvalitet

Lo compré a últimos de marzo. Lo he instalado en un elevador que me he fabricado de madera y la verdad que es super potente. Muy contento

Amazing push. Replaced the hydraulic cylinder on a 1000 lb lift cart. Still lifts at least 300 lbs (which is the most I've tried). 11" to 33" in ~25 seconds. Running on a Ryobi 18v drill battery. The maximum draw I've seen is 11 amps. But only for a second when starting from the lowest table height. I replaced the 30 amp fuse included with the battery holder with a 10 amp and it hasn't blown. Runs about 6 at mid to max heights in up mode. Down is less than 3 in any position. I won't be using it below 20" and only for a few inches/seconds at a time. I'm sure it will tolerate the extra 6 volts for my use. If not, I'll replace it and find a 12v solution. The bushings that reduce the base clevis from 12mm to 10mm are soft plastic and one was split. I didn't need them. It's odd that the piston clevis is 10mm and the base is 12mm. The included brackets are thin bent sheet and I wouldn't use them at high load. They wouldn't work for me anyway. Works better than my expectation in both speed and lift. I'm guessing adding a second actuator will give >500 lb capacity.

Prima apparaat, ik heb alleen de verkeerde lengte besteld! Dom nou hopen dat de kleinere snel weer beschikbaar is

All is very good

Jó termék.

Az ár érték szerint jó gép. Megfelelően működik. IP44 miatt az esőtől védeni kell.

there decent quality haven't used it yet .there kind of slow moving.

Working great so far,would definitely buy again, great price