Kundeanmeldelser for VEVOR Lineær aktuator 12V 12In Heavy Duty 1320lbs/6000N 0,19"/s IP44-beskyttelse

Il prodotto è completo e di buona fattura. Corrisponde perfettamente a quanto descritto nel sito. È potente, silenzioso e semplice nei collegamenti elettrici.

Étonné par la qualité et le prix je recommande

Op zich alles prima, maar geef aub hartafstanden aan tussen de pengaten. En het was beter als beide gaten dezelfde diameter hebben, nu een gat van 10 en andere zijde 12mn.

Arrived on time and this thing is well build and very strong. Good buy for the price and shipping, I would purchase again

VEVOR Actionneur Linéaire 12 V, Actionneur de Mouvement Linéaire Robuste 150 mm 6000 N 5 mm/s avec Support de Montage et Protection IP44 pour Portes Électriques, Machines Industrielles, Navires, Cargo Longueur d'Extension: 150 mm BON PRODUIT JE RECOMMANDE

Hebben hem ingebouwd als vervanger in een behandeltafel. Is 15 keer goedkoper dan de originele. Aan motor zijde is het scharnier 90 graden te verdraaien. Beugeltjes die er bij waren geleverd kunnen denk ik niet 6 kN aan. Hebben wij ook niet gebruikt omdat wij hem ingebouwd hebben in de behandeltafel.

Plug on 18volt ryobi selenoid ,m......................................................................

Utilisation sur tracker solaire depuis 6 mois... Fonctionne sans problème

Réalisation d'une petite presse avec 2 actionneurs linéaires. Vitesse a vide mesurée, 4,2mm/s

Amazing push. Replaced the hydraulic cylinder on a 1000 lb lift cart. Still lifts at least 300 lbs (which is the most I've tried). 11" to 33" in ~25 seconds. Running on a Ryobi 18v drill battery. The maximum draw I've seen is 11 amps. But only for a second when starting from the lowest table height. I replaced the 30 amp fuse included with the battery holder with a 10 amp and it hasn't blown. Runs about 6 at mid to max heights in up mode. Down is less than 3 in any position. I won't be using it below 20" and only for a few inches/seconds at a time. I'm sure it will tolerate the extra 6 volts for my use. If not, I'll replace it and find a 12v solution. The bushings that reduce the base clevis from 12mm to 10mm are soft plastic and one was split. I didn't need them. It's odd that the piston clevis is 10mm and the base is 12mm. The included brackets are thin bent sheet and I wouldn't use them at high load. They wouldn't work for me anyway. Works better than my expectation in both speed and lift. I'm guessing adding a second actuator will give >500 lb capacity.