Kundeanmeldelser for VEVOR lavprofil gulvjekk, 4 tonns kapasitet, stål racing gulvjekk med doble stempler hurtigløftepumpe, hydraulisk trillebilløfter for SUV, løfteområde 100–545 mm, gul og svart

This jack i thought was going to be better then the princess auto jacks you buy. I was so disappointed. The handle doesn't sit far enough down to properly tighten and loosen when turning the handle . The gap size is bigger where you put the handle onto at the base . I was soo disappointed. I had to modify it to use it . The cost to ship back and hope the next one better is not worth the money. Positive note. It lifts nicely for 4000 lbs jack lifted my half ton smoothly to change a tire.

its an okay jack acts like its got air in the system might need some more oil

Das Zahnrad zum Öffnen des Ventiles ist bilig gemacht Aber ansonsten ist es ok

The yolk (u- joint) is too short for the handle to connect properly, or the receiver side is too shallow (take your pick). While the build of this jack is fantastic, this is a major flaw over 2 different units sent to me. Without heavy modification the handle will NOT mesh properly with the yolk and will simply not engage.

Doesn't work that great for the price,given how big it is. It takes a lot of efort like most of my body weight to lift my truck side.

Jack lifts rated weight. Metal coating fades if left in sun. After unboxing and during first use center pad bolt pulled threads out of swivel plate. Should have gone with HF for local warranty. Not much price difference

Jack appears to be a good buy.. Easy assembly…

the jack is good, its a tank and hard to move around, but does what a jacks supposed to do and lift and lower a car!

Not to happy with the weight of the jack i thought it was an all aluminum jack to cut down on weight but it's not! a bit heavy for my use thx

I needed a bigger jack and purchased this one. Unboxing it went well the jack look very well built and was exactly what I needed. I have 3 issues with the jack. First off it was very difficult to bleed, but finally got it to bleed correctly. The universal joint that the handle attaches to lower the jack, is not long enough. I ended up welding a piece of square stock an inch long to the end of it just so the handle would work like it's suppose to. Last but not least one of the pins that threads into the side of the jack to allow the handle to "jack" the treads were completely stripped out of it.