Kundeanmeldelser for VEVOR manuell flisekutter, 1200 mm, porselensflisekutter med skjærehjul for wolframkarbid, infrarød posisjonering, sklisikre føtter, doble skinner for profesjonelle installatører eller nybegynnere

Usata per tagliare piastrelle 60x60 da 1cm,lavora bene,

Le Coupe-carreaux est très bien mais impossible de contacter Vervor je conseille donc de ne payer que par PayPal pour être sur de pouvoir contacter le vendeur via une réclamation. Dommage car le produit est bien.

Envio fora de prazo e sem rastreio. A máquina de corte de cerâmica manual chegou com defeito nas borrachas dos apoios laterais, enviei fotos da situação e estou a aguardar que enviem substituição da peça com defeito.

Sehr schnelle gute Lieferung produktkarton war beschädigt gerät aber in Ordnung

I bought this to cut large format tiles, 24 x 48. I have several smaller cutters. The trend to larger tile sizes forced me to get a new bigger one. The packaging looks good on the outside. However when I set it up and started using it I quickly realized it was going to be a challenge to get the job done correctly. One of the biggest gripes I have is they didn't calibrate the tool. There maybe a laser mounted on the head but as is out of the box it's useless. You will need to adjust it. Then I put a tile in and scored it, pressing the snap bar separated the two halves. pull it out from the bed and how off square could it be? Try 1/8" per foot. That is ridiculous. The rails seem too thin for the length that they are. The car slides nicely. There are these wings on the sides to support tile overhang. They are flimsy are get in the way if you're not using them. The unit is put together with nylock bolts and screws. Put aside 3 hours to setup and calibrate. It's not ready to use as is out of the box. Would look elsewhere for a more robust accurate tool.

Decent cutter for straight cuts. It’s would sometime chip the tile so you have to be careful.

Elle fait le travail mais sur du grand format genre 120x60 c’est plus que limite à rayer le carreau, l’axe a tendance à faire le ventre au milieu malheureusement. J’avais pris ce modèle justement pour éviter la flexion des doubles rails, mais au final c’est pas vraiment mieux. Ça coulisse mal, et le traçage via la molette n’est pas parfaitement droit. Le laser est un petit plus mais il manque de puissance. Il manque deux supports en plus de chaques côtés pour améliorer la stabilité Il vaut mieux partir sur un autre modèle pour faire du bon boulot.

Nicht zu vergleichen mit Profigeräten von Sigma,Kaufmann usw Bruchvorrichtung könnte besser sein manche Fliesen lassen sich nicht brechen da die Leitschiene sich durchbiegt Stahl wäre besser als Aluminium für den Heimwerker reicht es aber aus.

Flexes on the snap and score on long runs. Hard to compensate for the variance in accuracy

Appareil lui même très bien mais la barre supérieure est trop souple