Kundeanmeldelser for VEVOR manuell flisekutter, 1200 mm, porselensflisekutter med skjærehjul for wolframkarbid, infrarød posisjonering, sklisikre føtter, doble skinner for profesjonelle installatører eller nybegynnere

First of all, I’d like to say it’s a very good price which obviously means you’re going to get a cheaper product. If you’re just looking to do a couple of jobs this will get you by. It’s first of all the fence isn’t square and the laser beam is quite far off. You have to Jerry rig it to get it straight otherwise it cuts OK

Great for the price, first small job worked great had another small job and would not cut clean. Installed new diamond wheel and had same issues. Had to hand cut all tiles. So for a one and done it works great but dont expect it to be around for the long run.

uyjk

Worked well on one tile project not the second.

El cortador muy bien pero lo compré porque ponía que llegaría al siguiente día y tardo casi 3 semanas

Der Fliesenschneider ist nicht eingestellt, der Modus ist nicht genau

Dommage que la règle perpendiculaire à la coupe ne soit pas d'équerre ainsi que le laser, ce qui oblige à tracer des 2 cotés du carreau et visé la molette de coupe

The alignement of the cutter on the base is offset You have to align it and drill and grind the plastic at the end of the frame The frame is to soft When you cut and try to press to split the tile, the frame bind and it become hard to split I have to had steel piece under all the lenght the strength the frame After all that it's a good cheap tool

Could not get the laser to calibrate. Not easy to line up. Once lined up it cuts nicely.

The cutter is not square so the laser does not help. To make exact cut, it is necessary to place a tail checking whether the cutting wheel is placed on the top of the intended cut line on the one side of the tail, then on the other side so preparing for the cut takes time and adjustment. Beside of that, the video of the product and the manual attached to the product depict totally different version of the cutter (the real one does not have side supports and adjusted angle ruler). Customer service was not helpful at all so I did not get any replacement, I had to use what I got.