Kundeanmeldelser for VEVOR manuell flisekutter, 1200 mm, porselensflisekutter med skjærehjul for wolframkarbid, infrarød posisjonering, sklisikre føtter, doble skinner for profesjonelle installatører eller nybegynnere

Not the best, have to make alot of adjustments to get straight cuts, laser is never aligned with cutter don't bother using laser.

Works well for shorter lengths. Lacks strength for larger 4 ft porcelain tiles. Tried several tiles. Scored fine, but did not snap along long scores. Ruined several $75 tiles. Works fine with smaller tiles, bar bends with larger tiles. Planning to return.

Ho acquistato un tagliapiastrelle da 1200 ed è arrivato dopo ca una settimana, il prodotto si presenta bene ma non sembra di buona fattura. Provato ad utilizzare ed il raggio laser fuori linea si può registrare ma è impossibile allienarlo, provo a posizionare la mattonella e mi accorgo che è fuori squadra che è impossibile tagliare le mattonelle. Il 27/03 contatto l'assitenza e mi rispondono dicendo che valutano il problema, ad oggi 1/04 nonostante il sollecito non mi hanno risposto, molto negativo buttare i soldi, adesso chiedo il reso.

Je regrette vivement ce coupe-carrelage. Le rail manque de rigidité. Elle éclate les carreaux de carrelage, la coupe n'est pas nette. Difficulté à couper le carreau. Les extrémités des carreaux s'éclatent. J'ai contacté le Service après-vente.

El precio no esta mal pero esperaba algo más de calidad, el láser no funciona , al cortar las barras se doblan y los cortes no son rectos.

Je suis carreleur si vous souhaitez faire de belle coupe fuyez ce produit trop souple sur les guides attention sur carreaux 120 cm le guide de coupe pas d'équerre enfin bref c'est une belle daube

A priori, parfaite au déballage ! Matériaux corrects, laser livré avec piles, semble stable. Mais à l'utilisation, jusqu'à 60 cm sur du gré cérame italien de 8,9 mm , fait le job mais au delà c'est deux sur trois qui casse à la moitié. Même en forçant un peu plus sur la molette en bout de carreau, rien n'y fait ! Obligé de finir à la disqueuse pour rattraper les coupes rattrapables (quel gâchis de bon matériaux)

I have used one of these cutters a few years ago and it worked OK. Purchased this one and am very disappointed. Laser will not get closer than 1/8 inch out on 2 feet. Front and rear plates came out if square, plate bolts will not losen and just spins so no way to adjust plate. Rear screw behind laser plate seems stripped and will not tighten. Lots of issues. Purchased directly from the company because delivery time was faster than Amazon and it was needed for a project. Now will not have a cutter in time and am waiting for a reply from customer service. Highly disappointed to say the least. Never was able to even try the cutting wheel because of all the other issues.

Katastrofe Mann kann nicht ein fliesen richtig schneiden Wenn mann ausdückt zum zerbrechen die fliesen komplet die zwei seiten gehen hoch Erlich gesakt nie wieder so was kaufen

O produto recebido, em falta as baterias, o infravermelho não funciona. PRODUTO COM DEFEITO