Kundeanmeldelser for VEVOR Dekkskifter 96,5–106,7 cm Justerbar, Dekkmonteringsverktøy 250x150x120 mm Dekkjern Dekkspak Dekkmonteringsmaskin Dekkskiftverktøy Dekkspak Manuell

It works good with trailer tires or anything with smaller steel rims.

Very useful but will easily scratch up any rims if you are not super careful. On Tesla 18" rim it required clamps to compress the tire before it would even sit on the inner rim. Once in place, just keep turning and eventually the tire bead pops off, spray some liquid to help release it. The inside two feet are sharp and will create dents inside the rim. The outer rubber piece seems OK.

Difficult to use dont recomend

Blijkt niet te gebruiken voor winterbanden (oppervlak van stempel is veel te klein om het flexibele rubber van de velg te drukken) en banden die breder zijn dan de velg. Enige resultaat was dat velgen beschadigen.

The grease gun will not work. Batteries are fine. Tried many times. Many different ways. The gun would not load

Outil parfait pour abîmer les jantes. Il raye tout Livré avec tout les bords saillants j'ai dû les arrondir afin de moins abîmer, mais ça raye encore un peu. De plus le pied est trop petit, détruit souvent les pneus donc si vous comptez les réutiliser (roue de secours par exemple) faites très attention. Au bout de la quatrième utilisation seulement l'outil s'est déjà cassé.

Not value for money.i purchased the shipping protection insurance and found one small piece was missing and filed a claim and received an email that your claim has been well received and it's already a month I haven't heard any resolution from them.

Bonjour, Ne fonctionne pas sur jantes tôle remorque, ce pour quoi j'avais acheté. Obligé de revenir a la méthode voiture pour les décoller. Pas satisfait et un outil qui ne sert a rien. Déçu. Cordialement

The tool is very rough, poorly copied and will scratch and gouge into rims if not carefully and skillfully used.

I've bought a lot of good tools from Vevor, but this is not one of them. I had my doubts when I ordered this and I should have listened to my gut. The geometry is all wrong and the retaining arm can't get a purchase on the rim, so the unit slides off rim when pressure is applied. I ended up using my arbor press to break the bead on my tires so I could swap out TPMS sensors. Save your money on this one.