Kundeanmeldelser for VEVOR manuell avisoleringsmaskin, 1,5 mm–40 mm kobberavisoleringstang med håndsveiv eller drilldrevet, synlig avisoleringsdybde, bærbar aluminiumsramme-avisoleringstang for resirkulering av kobberskrap

Denudage uniquement très dur malgré une visseuse et le réglage impressi très dur pour les gros câbles 1000ro2v

Werkte voor mij totaal niet. Zeer veel op gevloekt, verschillende diktes geprobeerd. Kabel ging snel naast het mes. Ondertussen al lang bij het oud ijzer.

bonjour, j'ai acheté cette machine a dénudé je suis déçu. en 1.5 mm² malgré les réglages le fil reste pas sous la lame se qui empêche l'extraction du vinyle. j'ai envoyé un message a vôtre service mais sans réponse.

Vevor cant seem to send me my orders.. They used to be great.. I have now given up on using them.. Brent

Once again didn't get delivered.. Third time in the last month or so that I have tried to order items from Vevor.. Never had this issue on past orders... guess I will give up using vevor..

La machine degaine bien les gros cables mais ne fonctionne pas avec les cables de petites section de 1,5 et 2,5 mm2, Le cable sorte du guidage A fuir

NUL. Cette machine à dénuder est une arnaque. Réglage trop minutieux et la plus part du temps impossible pour centrer les engrenages et le disque de coupe. Inutilisable pour des fils de 1.5 ou 2.5mm². Le fil à dénuder sort de l'emplacement de coupe au bout de 2cm.

plastic adjusting knob on top broke first time I used it. very cheap. used 2 nuts and James them together. now and use a socket and ratchet to adjust.

Very surprised and disappointed at lack of quality check of unit before packing and shipping. Unit came partially assembled, Black plastic handle was already attached to metal handle arm which should attach to main body. Main body comes with a black metal D-shaft section (drive flat section) so as to attach the handle arm securely. The handle arm does not come with a corresponding D shaped hole in the arm,this would have improved its build quality. When trying to attach the handle arm to the shaft, it was noticed that the threaded pilot hole for the M8*12 hexagon screw (item 6 page 5) was not in the correct position on the arm. The M8 threaded hole appears to have been incorrectly installed at the wrong end of the handle arm next to the black plastic cylindrical handle. This has made the unit inoperable unless, we drill and tap the handle arm ourselves or replace the handle arm with an arm incorporating a D-shaft slot and M8 threaded locking screw hole. When you purchase a piece of equipment, we would normally expect to be able to use it fairly quickly once bolted and screwed together. In this situation, unit is unusable until handle issues are resolved.

The wire stripper works but is very difficult to keep the wire from twisting off the track. It could easily and cheaply be remedied by creating a tension-based restriction on both ends to hold the wire in an exact position and prevent twisting off the cutting wheel.