Kundeanmeldelser for VEVOR mekanisk nøkkelfri inngangsdørlås, 14-sifret tastatur, dørlåssett for utendørs port med overflatemontert lås, vanntett sinklegering, tastatur og knott, enkel å installere, for hage, gårdsplass, garasje

purchased 7 of these. 1 was missing parts and 1 does not work. Support has been dragging me along for months and still has not offered to replace the defective units. Recommend not purchasing this particular model until they have the bugs worked out.

Je sais pas si c'est moi mais quand je lai installer, si je serre trop les visse qui assemble la pogné elle vient dure a tourner et la clanche ne veut pas ressortir alors j'ai abandonné et remis ma vieille.

I still have it somewhere < it came with missing parts < I called and they give me a lot of excuses for return, bad customer service

I spent 1 hour adjusting the fitment then it won't lock. I used the second set to finally install it. My tenant claims it was too complicated and didn't always work. I removed it replace with original and put it back in the box through it in the corner make it up as a lesson and a loss

My husband has dementia and wanders so I needed a way to lock the door from the inside that had a code, not a key. This lock worked well at first, although the placement of the handle makes it difficult to put in the code and open. It is vertical, in front of the key pad making it difficult to use. It worked well for about a month. One night I went to open it and one of the keys was jammed and I could not unlock it. I tried everything I could but finally had to remove the lock completely, which left a hole in the door. I spend the next 3 hours trying to install another lock. I don't usually give bad reviews. I grew up with the "if you can't say something nice, don't say anything at all" motto, but I think a lock than fails is dangerous. I thought a mechanical lock would be safer than electronic, but not this time. Sorry to be so negative.

No me llegó completo los accesorios de instalación

Returns with Vevor is impossible. They run you around in circles. You have been warned.

Installation is not easy because of the flat bar for actuating the lock. The instructions are sorely lacking in this regard. One end of the bar has two "dimples" which must go into the combination side of the lock. There are 2 different lengths provide. I found that neither one worked for a 3.5" install and the longer one had to be cut. I cut it too short and did not have a working one because I inserted it the wrong way around. I ordered a replacement unit rather than try to get the part from tech support. Good thing I did too because the original one would not stay open fully, but "rebounded" about .5 inch not allowing the gate to close fully. However once I replaced the combo side3 of the lock with the new unit, it worked. I also rebuild my gate with 2x6s laid with the 1.5" side to mount the lock so that was room for the mechanism without having to add a block.

This entryway pushbutton lock system works pretty good after its installed, but the assembly was nerve wrecking! The two screws that secure the two halfs together on the door are all but impossible to start and screw in. It took me one hour of sweat and cuss words to finally get it together!!!! Not for the faint at heart

The directions aren't real explanatory on how to change the passcode I had to Google it online to figure out how to change the passcode The directions in the manual suck