Kundeanmeldelser for VEVOR metallbensinbeholder, 20 l, bensinkanne med tut og komfortabelt håndtak, 6 l/min maks. strømningshastighet, lekkasjesikker og korrosjonsbestandig metallbensintank de fleste biler motorsykkel ATV UTV, grønn

I bought 4 red and 1 yellow of the Vevor Upgraded Oil-Tight Metal Fuel Cans. There is a little piece of plastic which has a spring behind it (I found out) that keeps tenson on the spout as you tighten it down. Upon the very 1st fill-up at the gas station "2" of the red cans snapped the little plastic piece off and the spring shot out along with the plastic tensioner. I found the spring on the ground for 1 of them, but not the other. I like they are metal cans, but should be a handle on the back side to help hold it as you are filling your mower, etc.

I hate the nozzle

It said 'Jerry can'. 'Jerry cans' are coated on the inside!!

Le bec verseur n'est pas du tout pratique pour verser dans un réservoir autre que celui d'un véhicule.

I recently bought 2 metal gas cans. I liked them so much that I bought 2 more. That first 2 came with a metal spout that worked fine The second pair had cheap plastic spouts that leaked no matter how many times I repositioned the spout. CHEAP just like the ones you buy at Walmart.

I had the old style cam with the flexible nozzle, but I lost it, so I had to get a new one. This new nozzle is so hard to use. Gas leaks, the spring locking mechanism broke off on the first use, and the nozzle doesn’t close easily, so when I’m done fueling, gas shoots out when I lift the can up. I don’t know if they changed the nozzle for legal reasons, or because they thought this new one was better. It is not. Go back to the metal flexible nozzle.

Basically useless unless youre using gas right away…. Feels like it will explode because there is no venting. It also takes3 hands to pour because the spout is junk!

There's nothing wrong with the gas cans, as far as I can tell, other than that lack of a CSA or DOT certification. Gas stations that have attendants around (like Costco and others) will not let you fill these if they see them. Some work sites won't allow them around either. Personally think it is retarded; but, it is the world we live in.....

Worthless customer service.. ok products..hope u like it when u receive it, because u will never be able to make a. Return. Avoid at all costs

Warping Plastic Pour mechanism doesn’t work after some months. Gases with 10% Ethanol can diffuse directly through the microscopic pores of a plastic material. This can cause the plastic to bubble, warp, or fail over time, even if it does not melt instantly. Certain gases and volatile organic compounds (VOCs) can physically degrade, dissolve, or permeate plastics through a process known as chemical attack. Because plastics and many fuels share similar hydrocarbon structures, some gases compromise plastic integrity by weakening polymer bonds or causing the material to swell, distort, or dissolve entirely. How Gas Attacks Plastics Dissolution and Swelling: Ethanol acts as a strong solvent that can leach plasticizers from polymers, turning rigid plastics brittle or soft plastics. VEVOR Needs a updated metal cap to keep Plastic Pour mechanism out of the gas.