Kundeanmeldelser for VEVOR mobil base, kapasitet 600 kg, justerbar fra 46 x 61 cm til 66 x 89 cm, kraftig universal mobil basestativ med svingbare hjul, for trebearbeidingsutstyr, båndsag, elektroverktøy, maskiner

Excellent product. Works great!

I purchased the mobile base for my Delta table saw. The quality is there and it works perfectly, so easy to maneuver around. I would highly recommend this product. So far everything I have purchased from Vevor has been very well built and excellent quality.

Another winner from VEVOR. I bought 2 of these, 1 for my Sawstop 3hp PCS and the other for my Jet 14” bandsaw. They are super heavy dudy and work perfectly. Thanks!

Very good mobile base. easy to assemby

I had a base for my table saw but it wasn't built strong enough. It used 4 metal corner pieces with wheel casters held together with 2x2 lumber. This base is a beast. Easy to put together and very well built. You can adjust the length and width to suit your machine. My table saw weighs about 200 to 250 lbs. This will make it a lot easier to move around in and out of the garage for work around the house.

Super produit m'ayant permis de transformer mon établi pliable en établi à roulettes avec dessous un espace de rangement.

Bought to put my 30 year old table saw on to more easily move it around. Install instructions are porr as with most vevor products. Easy to figure out Could use about 4 more bolts to hold the frame together better.

Worked out great for my planer thicknesses. I was easily able to cut down two of the bars to make it fit my machine.

Very happy with this. Moves my bandsaw around without an issue. It's solid and tools smooth. I recommend it.

It is well made and fairly easy to assemble. I would have created a rectangular square hole guide. E. G between 15.5 and 17 use hole ...That way it would be faster. On a related not it should have either a solid base, or a larger corner support for mounting the base. It can still slide around on top of the support. An alternative would be some large screws that pushed in on all sides of the base using the holes on the 4 sides. I'll probably build something to hold it still. Finally, the base is angled when set up for moving. I would have like to see the design keep it level and raise and lower floor stops, not the whole frame. It works but when you have a 500lb top heavy drill press it's a little never racking to roll it around on an angle.