Kundeanmeldelser for VEVOR MR-13B Borsliper 3-13 mm Borsliper med 11 Hylser

I have to say this machine does a great job of sharpening evenly. The larger the drill bit the easier it is to index, even though the indexing part is finicky. "I" can't depend on centering/aligning the bit as required with the indexing part of the machine but I'm sure there is some room for error, just not much. Drill depth into the collet is good but alignment isn't so good sometimes. Using the directions that aren't great but work, tell you to bottom out then back out to your desired size. I needed to back it out more than that (about 2 turns out) then pay attention that it's correct. The smaller the bit is where it really becomes about useless except for depth and then becomes a juggling act. A word of Caution: to save the diamond wheel, a light touch is needed by taking your time - not to plunge too hard or hard at all - be patience and use light passes. Since Vevor doesn't sell replacement parts I'm not sure where to purchase a replacement wheel which aren't cheap I'm sure, so go easy on it (I haven't investigated this). I gave 3 stars on "Easy to Use" because of the alignment issues, but once set properly it's a breeze to use and it's quite too with the larger motor that is balanced nicely - smooth. It's a pretty heavy unit and I think it's Well Built overall. I sat down and sharpened an index full of fractional and numbered drill bits one day (size limited) and have to say it's a pleasure to use them now. I've used other sharpeners and this by far works better. Would be nice to accurately index really small bits - as mentioned before, the indexing suffers. The split point part of the machine works well also. I haven't experimented with all the split point options, but as set from factory works well. Very nice machine overall. :)