Kundeanmeldelser for VEVOR lommehulljiggsett, trippel lommehulljigg med skiftenøkkel og firkantinnfesting, dybeljigg for boring av lommehull og vinklede hull, borehjelpemiddel for trebearbeiding

I originally wanted to get a metal pocket hole jig for durality. However, I've used it only a few times and the drill bit consistently shaves off metal from the jig. There's enough play in the jig now that there is no way to consistently drill holes. I can't recommend another brand enough, just pay a higher price and you won't have to replace it in a few uses.

Too much plastic and very cheaply made. Will not last too long if used repeatedly. The sizes it grips is limited.

Love this jig but haven't had long . Was doing a slat wall pre drilled all my holes started putting up and realized all the heads of my screws stick out. Got to looking and the holes are wallered out. Jig is useless now . So is my project

Funkar bra för ett fåtal hål, men styrningarna för klena glappar efter ca 100 hål. Detta gör att efter ett tag blir hålen lite olika vinklar då alumimiummaterialet äte upp av borren Lätt att ställa in och skapade för material upp till 40mm.

The pocket hole jig bushings fall out every time you remove the drill bit. Other than that the pocket hole jig is what I expected. Much cheaper than the kreg jig but you generate you pay for.

Instructions are lacking big time, so newbies like me will have problems. Should not have to watch videos to figure it out.

Primer uso y se atascó

The tool has a great price but is not built to last. Ideal for someone needing to make a few dozen pocket holes, but does not stand up to repeated long term use. Bushings and bits quickly wore down.

I bought this to replace my kreg jig. It worked great for the first bunch of holes, I’d say around 50 or so but now the drill bit is eating away at the aluminum in the jig and the holes are no longer going into the piece deep enough. I now use the new drill bits and the clamp with my kreg jig. Would recommend Vevor upgrades to a larger steel guide bushing. The build quality is what really drags the overall rating down.

The jig does not hold position tightly enough. Even when screwing it into place very tight the drilling process would often move the jig leading to me drilling into the metal bottom plate a little ways.