Kundeanmeldelser for VEVOR Stolpehullsgraver Bensindrevet, 43CC 1250W Jordbor, Gassbor med 8” Boremekanisme Designbits, Stolpehullsgraver for Gjerdeplanter, Oransje + Svart

Does it drill holes? Yes. The only issue I have is that you should never lay it down on its side while running because air bubbles will get pulled through the fuel pick up line, regardless of having a full tank, causing the motor to run away and turning the auger into the world's most dangerous Skip-It. Even when standing straight up at times, if a bubble runs through, the throttle gets a mind of its own and it'll rev up and spin out of control.

I purchased the 52cc auger. It worked great for a few holes. However the plastic sheathing holding the wires and throttle cable got caught on the 10” bit and broke. Obviously this was my mistake as I should have used the zip ties and fastened the tubing down to the handle bars. I went off pictures of the completed tool online and noticed zip ties were not used as the tubing and wires just hung freely. Lesson learned the hard way. I was able to repair the black and red wires, not sure how long they’ll last. It would be nice if Vevor sold a throttle cable and wire assembly separate. Now I’m stuck looking for an off brand throttle cable. The end of the cable that connects to the engine, broke off so now the cable has no way of staying in the slot on the engine.

Reçu l’appareil qui fonctionne hyper bien mais attention manque de trois vis qui tiennent le moteur heureusement que j’ai vu sinon le moteur volé

Its ok as long as you dont hit roots or rocks. Got it stuck in clay and took 2 hours of digging to get it out

Très difficile à mettre en route ..(air dans le circuit carburateur).. mais quand elle démarre, on peut faire du beau travail !

Haven't received my order yet , said it would be delivered in a couple days until I purchased and now it's just stuck at ups saying shipping label created , been almost 2 weeks

I ordered the posthold digger and it came box all damage and missing parts. It took him over a month to send the parts and 20 emails. Not understanding, I just needed nuts and bolts. The machine works great, but customer service did not help me to the point where I was frustrated. Just for nuts and bolts, I sent pictures after pictures and emails after emails. And whoever was helping me didn't understand or don't speak English, I don't think I would order again. When you have to talk to customer service via email, it's a headache and not worth it. This company does not have a phone number and will waste your time. So if you buy something from them, get ready for a headache, if something's wrong.

This thing has too much vibration when using it. The shaft needs to be one piece to reduce vibration.

Power was great on first 3 holes. Went to start it and the pull cord wouldn't retract. Have to take apart all the casing to try and repair and not confident I wont have to replace the spring mechanism. After less than 10 pulls, this was extremely disappointing and hindered the work needed to be done.

Horribly Manuel… One or two things reference that are inaccurate such as oil maintenance. Item also came with missing parts and about six emails before somebody understood what was needed. Still a good value for what it is, but all visible signs of quality around the literature and Customerservice just make you cringe to think if you have a problem