Kundeanmeldelser for VEVOR Stolpehullsgraver Bensindrevet, 52CC 1450W Jordbor, Gassbor med 6” og 10” Boremekanisme Designbits og 3 Forlengelsesstenger, Stolpehullsgraver for Hageplanter i jordbruksland, Oransje + Svart

La calidad de construcción es excelente. Dos puntos importantes: necesitas tener bastante fuerza y, en terrenos muy duros o difíciles, conviene mojarlos la noche anterior.

The auger works great, after some fiddling. Upon first start-up, the RPMs were too high and we couldn't get the bit to stop spinning. The reason is because the throttle cable would not allow the throttle arm to fully return against the idle speed adjustment screw; the cable isn't long enough. So, I removed the cover, tilted and lifted the cable-end out of its hole in the throttle arm and moved it back one hole. Problem solved. I don't understand how it left the factory like this, especially considering that I bought two of these augers, and both had the same problem. Easy fix, but odd and unpleasant surprise upon first start-up.

Impeccable

Hele goede

Livrée rapidement, tout en un seul colis: fraises et bloc moteur. Pas de perte. Facile à monter. Efficace avec les 2 fraises, 150 et 250. Un seul bémol: pas facile à lancer, sans doute un peu trop d'avance à l'allumage et moteur neuf. Forte compression; attention aux doigts avec la poignée de lanceur. Par contre, une fois lancée, la tarière tourne très bien et montre une bonne puissance, même avec la fraise de 250. Au ralenti, les fraises sont bien débrayées. Pas trop lourde à déplacer, mais suffisamment pour creuser seule en terre caillouteuse.

Naja es macht was es soll! Keine Stihl Qualität!

Received promptly. Tried it out. Started first go. The primer pump is in a hard to reach spot thanks to the covers. Overall good value for money. Quicker than digging.

Produto chegou com o acelerador partido tive de encomendar um novo no aliexpres A empresa de transporte não teve cuidado.

It's a good tool. I have used it to drill 5/6 fence posts holes. Worked pretty well. There is one issue I found with the locking pin (see attached photo). The locking pin got deformed after use. My concern is that with continuous use the locking pin will eventually break. Replacing the pin with a bit stronger material, maybe a steel pin, might work better and will be safer (but I am not sure if there is a reason for using the softer material? anyway...) Since it is deformed it will not fit now. So I am trying to find the same size locking pin in the hardware store for my next use.

They are great but the packaging is very poorly done, they get to me most missing screws and nuts. Need to put more attention to packaging